Hybrid Multilevel Inverter using ISPWM Technique for Fuel Cell Applications

Fuel cells have been considered as the primary energy source for the distributed power generation as they are highly efficient, modular and clean. The main drawback is that the dc voltage generated by a single fuel cell varies from 0.7V to 1V. Due to the low input voltage in fuel cells, a suitable power conditioner is required to interface to the utility grid or local loads. To meet this requirement, this paper presents the design, development and performance of a hybrid cascaded multilevel inverter. The advantage of the proposed topology is that the modulation, control and protection requirements of each bridge are modular and it requires only a single dc source in each phase leg. A twolevel H-bridge inverter using variable frequency inverted sine wave carrier modulation technique has been studied for total harmonic distortion (THD) and switching losses for fuel cell applications. A detailed study of the technique was carried out through MATLAB/SIMULINK for switching losses and THD. The results were verified experimentally. It was noticed that the proposed modulation strategy results in lower switching losses for a chosen THD as compared to the conventional strategies. General Terms Design, Verification

[1]  Zhong Du,et al.  Optimum fuel cell utilization with multilevel inverters , 2004, 2004 IEEE 35th Annual Power Electronics Specialists Conference (IEEE Cat. No.04CH37551).

[2]  Vassilios G. Agelidis,et al.  Analysis of multicarrier PWM methods for a single-phase five level inverter , 2001, 2001 IEEE 32nd Annual Power Electronics Specialists Conference (IEEE Cat. No.01CH37230).

[3]  D.G. Holmes,et al.  A comparison of multicarrier PWM strategies for cascaded and neutral point clamped multilevel inverters , 2000, 2000 IEEE 31st Annual Power Electronics Specialists Conference. Conference Proceedings (Cat. No.00CH37018).

[4]  Brendan Peter McGrath,et al.  Multicarrier PWM strategies for multilevel inverters , 2002, IEEE Trans. Ind. Electron..

[5]  Leon M. Tolbert,et al.  Hybrid Cascaded H-bridges Multilevel Motor Drive Control for Electric Vehicles , 2006 .

[6]  S. Jeevananthan,et al.  Inverted Sine Carrier for Fundamental Fortification in PWM Inverters and FPGA Based Implementations , 2007 .

[7]  Marco Furini,et al.  International Journal of Computer and Applications , 2010 .

[8]  Z.D. Far,et al.  Introduction and evaluation of novel multi-level carrier-based PWM strategies using a generalized algorithm , 2007, 2007 European Conference on Power Electronics and Applications.

[9]  Leon M. Tolbert,et al.  Multilevel converters as a utility interface for renewable energy systems , 2000, 2000 Power Engineering Society Summer Meeting (Cat. No.00CH37134).

[10]  A. Radan,et al.  Evaluation of Carrier-Based PWM Methods for Multi-level Inverters , 2007, 2007 IEEE International Symposium on Industrial Electronics.