Increasing the wear resistance of molds for injection of glass fiber reinforced plastics

[1]  R. P. Martinho,et al.  TiB2 nanostructured coating for GFRP injection moulds. , 2011, Journal of nanoscience and nanotechnology.

[2]  Weite Wu,et al.  Mechanical properties of gradient and multilayered TiAlSiN hard coatings , 2009 .

[3]  R. P. Martinho,et al.  Influence of the abrasive particles size in the micro-abrasion wear tests of TiAlSiN thin coatings , 2009 .

[4]  R. P. Martinho,et al.  Micro-abrasion wear behaviour of TiAlCrSiN nanostructured coatings , 2009 .

[5]  Jinju Chen,et al.  On the factors affecting the critical indenter penetration for measurement of coating hardness , 2009 .

[6]  A. Schütze,et al.  Mechanical properties and failure modes of TiAl(Si)N single and multilayer thin films , 2003 .

[7]  L. Fedrizzi,et al.  Low temperature plasma immersion ion implantation of nitrogen on a mould steel , 2002 .

[8]  S. Bull,et al.  A simulation test for wear in injection moulding machines , 2001 .

[9]  A. Matthews,et al.  On the significance of the H/E ratio in wear control: a nanocomposite coating approach to optimised tribological behaviour , 2000 .

[10]  R. I. Davidson,et al.  A simulation test for the selection of coatings and surface treatments for plastics injection moulding machines , 2000 .

[11]  John A. Thornton,et al.  Influence of apparatus geometry and deposition conditions on the structure and topography of thick sputtered coatings , 1974 .

[12]  Katsuhiko Ariga,et al.  Nanoarchitectonics: a conceptual paradigm for design and synthesis of dimension-controlled functional nanomaterials. , 2011, Journal of nanoscience and nanotechnology.