Investigating the performance of a water-based photovoltaic/thermal (PV/T) collector in laminar and turbulent flow regime

The objective of this work is to simulate a water-based flat plate photovoltaic/thermal system with glass cover and without it in laminar and turbulent regime and investigating the effects of solar irradiation, packing factor, Reynolds number, collector length, pipes diameter and number of pipes on the performance of this system. The accuracy of the model has been validated with the available data in the literature, where good agreements between the results have been achieved. The results showed that the energy efficiency in the glazed photovoltaic/thermal system is higher than unglazed one, while its exergy efficiency depends on the packing factor, Reynolds number and collector length. The results also indicated that increasing of solar radiation and packing factor increases total energy and exergy efficiency in both laminar and turbulent regime. Besides, it was found that there are the optimum values for mass flow rate and number of pipes that maximize exergy efficiency. The value of the optimum mass flow rate is larger in the case of unglazed system compared to that of glazed one. Furthermore, in most cases, the total energy efficiency in turbulent regime is higher, whereas the total exergy efficiency in laminar regime is superior.

[1]  Amin Shahsavar,et al.  Energy and Exergy Analysis of a Photovoltaic-Thermal Collector With Natural Air Flow , 2012 .

[2]  T. Unny,et al.  Free convective heat transfer across inclined air layers , 1976 .

[3]  Jie Ji,et al.  Effect of fluid flow and packing factor on energy performance of a wall-mounted hybrid photovoltaic/water-heating collector system , 2006 .

[4]  Gang Pei,et al.  Effects of frame shadow on the PV character of a photovoltaic/thermal system , 2014 .

[5]  Niccolò Aste,et al.  Water flat plate PV–thermal collectors: A review , 2014 .

[6]  W. Swinbank.  Long‐wave radiation from clear skies , 1963 .

[7]  K. Touafek,et al.  Theoretical and experimental study of sheet and tubes hybrid PVT collector , 2014 .

[8]  Mohammad Charjouei Moghadam,et al.  Experimental and numerical investigation of nanofluids heat transfer characteristics for application in solar heat exchangers , 2016 .

[9]  Luigi Marletta,et al.  Exergy and thermoeconomic optimization of a water-cooled glazed hybrid photovoltaic/thermal (PVT) collector , 2014 .

[10]  Andrew A. O. Tay,et al.  Testing of two different types of photovoltaic–thermal (PVT) modules with heat flow pattern under tropical climatic conditions , 2013 .

[11]  Tin-Tai Chow,et al.  Performance analysis of photovoltaic-thermal collector by explicit dynamic model , 2003 .

[12]  Mehran Ameri,et al.  Experimental investigation and modeling of a direct-coupled PV/T air collector , 2010 .

[13]  V. Badescu.  Accurate upper bound for the efficiency of converting solar energy into work , 1998 .

[14]  Viorel Badescu.  How much work can be extracted from a radiation reservoir , 2014 .

[15]  Dae Hyun Kim,et al.  Simulation and model validation of sheet and tube type photovoltaic thermal solar system and conventional solar collecting system in transient states , 2012 .

[16]  Behrooz M. Ziapour,et al.  Performance comparison of four passive types of photovoltaic–thermal systems , 2014 .

[17]  K. F. Fong,et al.  Energy and exergy analysis of photovoltaic-thermal collector with and without glass cover , 2009 .

[18]  Viorel Badescu,et al.  Unified upper bound for photothermal and photovoltaic conversion efficiency , 2008 .

[19]  Said Farahat,et al.  Optimization of a solar photovoltaic thermal (PV/T) water collector based on exergy concept , 2014 .

[20]  Viorel Badescu,et al.  Is Carnot efficiency the upper bound for work extraction from thermal reservoirs? , 2014 .

[21]  Siddig Omer,et al.  Advancements in hybrid photovoltaic systems for enhanced solar cells performance , 2015 .

[22]  R. Shah,et al.  Laminar Flow Forced Convection in Ducts: A Source Book for Compact Heat Exchanger Analytical Data , 2014 .

[23]  W. Beckman,et al.  Solar Engineering of Thermal Processes , 1985 .

[24]  Soteris A. Kalogirou,et al.  Hybrid PV/T solar systems for domestic hot water and electricity production , 2006 .

[25]  Oussama Rejeb,et al.  A numerical investigation of a photovoltaic thermal (PV/T) collector , 2015 .

[26]  Niccolò Aste,et al.  Design, modeling and performance monitoring of a photovoltaic–thermal (PVT) water collector , 2015 .

[27]  Viorel Badescu,et al.  Statistical thermodynamic foundation for photovoltaic and photothermal conversion III: Application to hybrid solar converters , 1997 .

[28]  Bin-Juine Huang,et al.  PERFORMANCE EVALUATION OF SOLAR PHOTOVOLTAIC / THERMAL SYSTEMS , 2001 .

[29]  V. Badescu,et al.  Thermal inertia of flat-plate solar collectors in different radiative regimes , 2016 .

[30]  Anil Kumar,et al.  Historical and recent development of photovoltaic thermal (PVT) technologies , 2015 .

[31]  R. Petela.  Exergy of Heat Radiation , 1964 .

[32]  A. D. Young,et al.  An Introduction to Fluid Mechanics , 1968 .

[33]  Kamaruzzaman Sopian,et al.  Performance analysis of photovoltaic thermal (PVT) water collectors , 2014 .

[34]  Xingxing Zhang,et al.  Review of R&D progress and practical application of the solar photovoltaic/thermal (PV/T) technologies. , 2012 .

[35]  Ha Herbert Zondag,et al.  The thermal and electrical yield of a PV-thermal collector , 2002 .