A Low-Dropout Regulator With Smooth Peak Current Control Topology for Overcurrent Protection

The proposed low-dropout (LDO) regulator with a smooth peak current control (SPCC) circuit can be simultaneously controlled by using an error amplifier to regulate output voltage and a peak current controller as a means to limit its current level. The SPCC circuit can be switched smoothly between these two control mechanisms by detecting the information of load current and the dropout voltage. Measured results show that overcurrent protection can make the pass device operate as a current source while the load current exceed the peak current level. Moreover, the control mechanism can return to error amplifier control when load current becomes smaller than the limiting current, thus ensuring output voltage to be close to the rated value. Output voltage is stable and varies smaller than 15 mV when a 160 mA load current step or a 2 V supply voltage step is placed on this LDO regulator.

[1]  Ke-Horng Chen,et al.  Low-Dropout Regulators With Adaptive Reference Control and Dynamic Push–Pull Techniques for Enhancing Transient Performance , 2009, IEEE Transactions on Power Electronics.

[2]  W. Kruiskamp,et al.  Low drop-out voltage regulator with full on-chip capacitance for slot-based operation , 2008, ESSCIRC 2008 - 34th European Solid-State Circuits Conference.

[3]  Ke-Horng Chen,et al.  Smooth Pole Tracking Technique by Power MOSFET Array in Low-Dropout Regulators , 2008, IEEE Transactions on Power Electronics.

[4]  Ke-Horng Chen,et al.  High-performance low-dropout regulator achieved by fast transient mechanism , 2008, ESSCIRC 2008 - 34th European Solid-State Circuits Conference.

[5]  Xiaogao Xie,et al.  Analysis and Optimization of LLC Resonant Converter With a Novel Over-Current Protection Circuit , 2005, IEEE Transactions on Power Electronics.

[6]  Mohammad A. Al-Shyoukh,et al.  A Transient-Enhanced Low-Quiescent Current Low-Dropout Regulator With Buffer Impedance Attenuation , 2007, IEEE Journal of Solid-State Circuits.

[7]  Ke-Horng Chen,et al.  Low-Ripple and Dual-Phase Charge Pump Circuit Regulated by Switched-Capacitor-Based Bandgap Reference , 2009, IEEE Transactions on Power Electronics.

[8]  Ke-Horng Chen,et al.  Fast Transient DC-DC Converter with On-Chip Compensated Error Amplifier , 2006 .

[9]  Ke-Horng Chen,et al.  A Charge-Recycling Buck-Store and Boost-Restore (BSBR) Technique With Dual Outputs for RGB LED Backlight and Flashlight Module , 2009, IEEE Transactions on Power Electronics.

[10]  Robert G. Meyer,et al.  Analysis and Design of Analog Integrated Circuits , 1993 .

[11]  Gabriel A. Rincon-Mora,et al.  Cancellation of load regulation in low drop-out regulators , 2002 .

[12]  T. Karnik,et al.  Area-efficient linear regulator with ultra-fast load regulation , 2005, IEEE Journal of Solid-State Circuits.

[13]  Feng Quan-yuan,et al.  Design of current limiting circuit in low dropout linear voltage regulator , 2005, 2005 Asia-Pacific Microwave Conference Proceedings.