Experimental and numerical studies of local current mapping on a PEM fuel cell

Local current distribution on a PEM fuel cell has been mapped experimentally by using a special-designed single cell fixture. It is composed of a composite cathodic flow-field plate, a membrane electrode assembly (MEA) and a stainless-steel anodic flow-field plate. An array of 16 individual conductive segments was distributed on the composite plate. A self-made MEA is in direct contact with the segmented current collectors. Regional-averaged current through each segment is determined by using the Hall-effect sensor. To ensure the data reliability, a comparison of polarization curves was made between the composite flow-field plate and the conventional flow-field plate. Then, the effects of flow-field patterns, dew points of the cathodic feedings and cathodic stoichiometrics on the local current distribution were examined. The transient variation of the local current distribution on the cathode under supersaturated conditions was further visualized to illustrate the flooding phenomena in different flow patterns. This technique developed by the present work has contributed to knowledge and understanding the local current distributions in a PEM fuel cell that is helpful in designing the fuel-cell components.

[1]  D. Wilkinson,et al.  In-situ methods for the determination of current distributions in PEM fuel cells , 1998 .

[2]  J. Banhart,et al.  Combined neutron radiography and locally resolved current density measurements of operating PEM fuel cells , 2008 .

[3]  Lin Wang,et al.  Separate measurement of current density under the channel and the shoulder in PEM fuel cells , 2008 .

[4]  Jenn-Jiang Hwang,et al.  Thermal-fluid transports in a five-layer membrane-electrode assembly of a PEM fuel cell , 2006 .

[5]  Jenn-Jiang Hwang,et al.  Heat/mass transfer in porous electrodes of fuel cells , 2006 .

[6]  Ned Djilali,et al.  Flow Structures in a U-Shaped Fuel Cell Flow Channel: Quantitative Visualization Using Particle Image Velocimetry , 2005 .

[7]  Hong Sun,et al.  PEM fuel cell performance and its two-phase mass transport , 2005 .

[8]  Detlef Stolten,et al.  In situ approach for current distribution measurement in fuel cells , 2006 .

[9]  P. Lund,et al.  Measurement of current distribution in a free-breathing PEMFC , 2002 .

[10]  Chao-Yang Wang,et al.  Liquid Water Transport in Gas Diffusion Layer of Polymer Electrolyte Fuel Cells , 2004 .

[11]  Christopher Hebling,et al.  Spatially resolved measurement of PEM fuel cells , 2005 .

[12]  T. Baumhöfer,et al.  Measurement of the current distribution in a direct methanol fuel cell : confirmation of parallel galvanic and electrolytic operation within one cell , 2008 .

[13]  Chang-Gi Kim,et al.  Numerical analysis of a polymer electrolyte fuel cell , 2004 .

[14]  Jenn-Jiang Hwang,et al.  Development of a lightweight fuel cell vehicle , 2005 .

[15]  Jenn-Jiang Hwang,et al.  A three-dimensional numerical simulation of the transport phenomena in the cathodic side of a PEMFC , 2004 .

[16]  Liejin Guo,et al.  Effects of humidification temperatures on local current characteristics in a PEM fuel cell , 2007 .

[17]  K. S. Weil,et al.  Development of a niobium clad PEM fuel cell bipolar plate material , 2007 .

[18]  Jenn-Jiang Hwang,et al.  A complete two-phase model of a porous cathode of a PEM fuel cell , 2007 .

[19]  Suresh G. Advani,et al.  Experimental investigation of liquid water formation and transport in a transparent single-serpentine PEM fuel cell , 2007 .

[20]  Won-Yong Lee,et al.  Current distribution in a single cell of PEMFC , 2003 .

[21]  Daniel G. Strickland,et al.  Current distribution in polymer electrolyte membrane fuel cell with active water management , 2007 .

[22]  Mahlon Wilson,et al.  A printed circuit board approach to measuring current distribution in a fuel cell , 1998 .

[23]  Chao-Yang Wang,et al.  A Nonisothermal, Two-Phase Model for Polymer Electrolyte Fuel Cells , 2006 .

[24]  Jenn-Jiang Hwang,et al.  Modeling of two-phase temperatures in a two-layer porous cathode of polymer electrolyte fuel cells , 2007 .

[25]  S. Dutta,et al.  Numerical prediction of mass-exchange between cathode and anode channels in a PEM fuel cell , 2001 .

[26]  B. Wahdame,et al.  Comparison between two PEM fuel cell durability tests performed at constant current and under solicitations linked to transport mission profile , 2007 .

[27]  Hongtan Liu,et al.  A novel technique for measuring current distributions in PEM fuel cells , 2006 .

[28]  W. Lehnert,et al.  Current distribution mapping in polymer electrolyte fuel cells—A finite element analysis of measurement uncertainty imposed by lateral currents , 2006 .

[29]  Sirivatch Shimpalee,et al.  Numerical studies on rib & channel dimension of flow-field on PEMFC performance , 2007 .