Online Efficiency Optimization of a Closed-Loop Controlled SiC-Based Boost Converter

This paper presents an online optimization strategy for a silicon-carbide (SiC) based Boost converter where the converter switching frequency and dead times are adjusted to set the peak synchronous-rectifier (SR) turn-off current so that zero-voltage switching quasi-square-wave (ZVS-QSW) operation is achieved at any given operating point while minimizing inductor current ripple. The optimal converter switching frequency and dead times are determined based on sensed converter input/output voltages and inductor current using multidimensional parametric curve fit. These timing parameters are applied to the converter in a low-bandwidth feed-forward path operating in conjunction with closed-loop regulation of the converter output voltage. Experimental validation of the online optimization strategy is carried out on a 10kW, 600V converter prototype, demonstrating a close match between analytically computed and curve-fit based switching frequency and dead times over wide ranges of operating points. The proposed approach enables operation of the converter with efficiencies greater than 97.5% for input voltages ranging from 200V to 400V, conversion ratios up to 2.5, and power levels between 2kW and 8kW.

[1]  J. W. Kolar,et al.  Interleaved Triangular Current Mode (TCM) resonant transition, single phase PFC rectifier with high efficiency and high power density , 2010, The 2010 International Power Electronics Conference - ECCE ASIA -.

[2]  Sang Hee Kang,et al.  Efficiency Optimization in Digitally Controlled Flyback DC–DC Converters Over Wide Ranges of Operating Conditions , 2012, IEEE Transactions on Power Electronics.

[3]  Paolo Mattavelli,et al.  Digital control of high-frequency switched-mode power converters , 2015 .

[4]  Fred Wang,et al.  Optimal Dead-time Setting and Loss Analysis for GaN-based Voltage Source Converter , 2018, 2018 IEEE Energy Conversion Congress and Exposition (ECCE).

[5]  Alex Q. Huang,et al.  Predictive ZVS Control With Improved ZVS Time Margin and Limited Variable Frequency Range for a 99% Efficient, 130-W/in3 MHz GaN Totem-Pole PFC Rectifier , 2019, IEEE Transactions on Power Electronics.

[6]  Dragan Maksimovic,et al.  Circuit-Oriented Treatment of Nonlinear Capacitances in Switched-Mode Power Supplies , 2015, IEEE Transactions on Power Electronics.

[7]  I. Batarseh,et al.  Maximum Efficiency Point Tracking (MEPT) Method and Digital Dead Time Control Implementation , 2006, IEEE Transactions on Power Electronics.

[8]  Leon M. Tolbert,et al.  Model-Based Dead Time Optimization for Voltage-Source Converters Utilizing Silicon Carbide Semiconductors , 2017, IEEE Transactions on Power Electronics.

[9]  Khai D. T. Ngo.  Generalization of resonant switches and quasi-resonant DC-DC converters , 1987, IEEE Power Electronics Specialists Conference.

[10]  Dragan Maksimovic,et al.  Sensorless optimization of dead times in dc–dc converters with synchronous rectifiers , 2006, IEEE Transactions on Power Electronics.

[11]  Matthias Preindl,et al.  Optimal-Frequency Critical Soft Switching Method of Synchronous DC/DC Converter Based on Model Predictive Control , 2019, 2019 IEEE Applied Power Electronics Conference and Exposition (APEC).

[12]  I. Batarseh,et al.  Adaptive Digital Controller and Design Considerations for a Variable Switching Frequency Voltage Regulator , 2009, IEEE Transactions on Power Electronics.

[13]  Matthias Preindl,et al.  Optimal Frequency and Critical Soft Switching Control of DC/DC Converter , 2019, 2019 IEEE Energy Conversion Congress and Exposition (ECCE).

[14]  D. Maksimović,et al.  Drive-Cycle Optimized 99% Efficient SiC Boost Converter Using Planar Inductor with Enhanced Thermal Management , 2019, 2019 20th Workshop on Control and Modeling for Power Electronics (COMPEL).

[15]  D. Maksimović.  Design of the zero-voltage-switching quasi-square-wave resonant switch , 1993, Proceedings of IEEE Power Electronics Specialist Conference - PESC '93.

[16]  C. Henze,et al.  Zero-voltage switching in high frequency power converters using pulse width modulation , 1988, APEC '88 Third Annual IEEE Applied Power Electronics Conference and Exposition.

[17]  Yen-Shin Lai,et al.  A Family of Predictive Digital-Controlled PFC Under Boundary Current Mode Control , 2012, IEEE Transactions on Industrial Informatics.