Numerical and experimental analysis of resin flow and cure in resin injection pultrusion (RIP)

This work presents the results of modeling, numerical simulation, and experimental study of resin flow and heat transfer in the resin injection pultrusion (RIP) process. A control volume/finite element method (CV/FEM) was used to solve the flow governing equations, together with heat transfer and chemical reaction models. Resin viscosity, degree of cure, and fiber stack compressibility and permeability were measured in order to understand their influences on the process. An analytical flow model has also been developed based on the one-dimensional flow approximation for the resin flow in the injection die. A high-pressure small-taper injection die was tested with different line speeds. Experimental data were used to verify the simulation results and the analytical solutions.

[1]  Ravi Gorthala,et al.  Resin Flow, Cure and Heat Transfer Analysis for Pultrusion Process , 1994 .

[2]  Timothy G. Gutowski,et al.  The Consolidation of Laminate Composites , 1987 .

[3]  L. J. Lee,et al.  Non-isothermal Mold Filling and Curing Simulation in Thin Cavities with Preplaced Fiber Mats , 1991 .

[4]  Wen-Bin Young,et al.  Analysis of resin injection molding in molds with preplaced fiber mats. II: Numerical simulation and experiments of mold filling , 1991 .

[5]  S. J. Wineman,et al.  Consolidation Experiments for Laminate Composites , 1987 .

[6]  Christian Masson,et al.  Co‐located equal‐order control‐volume finite element method for two‐dimensional axisymmetric incompressible fluid flow , 1994 .

[7]  J. Kardos,et al.  Modeling of injected pultrusion processes: A numerical approach , 1998 .

[8]  J. Westhuizen,et al.  Quantification of Unidirectional Fiber Bed Permeability , 1994 .

[9]  Cheng-Hsien Wu,et al.  Trans‐plane fluid permeability measurement and its applications in liquid composite molding , 1994 .

[10]  Stephen P. McCarthy,et al.  Compressibility and relaxation of fiber reinforcements during composite processing , 1991 .

[11]  J. L. Kardos,et al.  3-D Nonisothermal Flow Simulation Model for Injected Pultrusion Processes , 1999 .

[12]  B. R. Gebart,et al.  Permeability of Unidirectional Reinforcements for RTM , 1992 .

[13]  L. J. Lee,et al.  Analysis of resin injection molding in molds with preplaced fiber mats. I: Permeability and compressibility measurements , 1991 .