A Ducted Photovoltaic Façade Unit with Buoyancy Cooling Part I Experiment

A ducted photovoltaic facade (DPV) unit was studied using experimental prototype and simulated in a full scale computational fluid dynamics (CFD) model. The study comes in two parts; this is Part I, as detailed in the title above, and Part II is titled “A Ducted Photovoltaic Facade Unit with Buoyancy Cooling: Part II CFD Simulation”. The process adopted in the experimental study is replicated in the simulation part. The aim was to optimize the duct width behind the solar cells to allow for a maximum buoyancy-driven cooling for the cells during operation. Duct widths from 5 to 50 cm were tested in a prototype. A duct width of 45 cm had the maximum calculated heat removed from the duct; however, the lowest cell-operating temperature was reported for duct width of 50 cm. It was found that ΔT between ducts’ inlets and outlets range from 5.47 °C to 12.32 °C for duct widths of 5–50 cm, respectively. The ducted system enhanced module efficiency by 12.69% by reducing photovoltaic (PV) temperature by 27 °C from 100 °C to 73 °C. The maximum measured heat recovered from the ducted PV system was 422 W. This is 48.98% from the incident radiation in the test. The total sum of heat recovered and power enhanced by the ducted system was 61.67%.

[1]  Lin Lu,et al.  Investigation on the annual thermal performance of a photovoltaic wall mounted on a multi-layer façade , 2013 .

[2]  Yogesh Jaluria,et al.  Natural Convection: Heat and Mass Transfer , 1980 .

[3]  Oussama Chehab.  The intelligent façade photovoltaic and architecture , 1994 .

[4]  Parham A. Mirzaei,et al.  Investigation of the role of cavity airflow on the performance of building-integrated photovoltaic panels , 2014 .

[5]  Alberto Barbaresi,et al.  Retrofit interventions in non-conditioned rooms: calibration of an assessment method on a farm winery , 2017 .

[6]  Hongxing Yang,et al.  Using phase change materials in photovoltaic systems for thermal regulation and electrical efficiency improvement: A review and outlook , 2015 .

[7]  Y. Tripanagnostopoulos,et al.  Performance improvement of PV/T solar collectors with natural air flow operation , 2008 .

[8]  Tin-Tai Chow,et al.  A Review on Photovoltaic/Thermal Hybrid Solar Technology , 2010, Renewable Energy.

[9]  Guohui Gan,et al.  Numerical determination of adequate air gaps for building-integrated photovoltaics , 2009 .

[10]  Mats Sandberg,et al.  Ventilated-solar roof air flow and heat transfer investigation , 1998 .

[11]  Abdel Rahman Elbakheit.  Effect of Duct Width in Ducted Photovoltaic Facades , 2008 .

[12]  Mats Sandberg,et al.  Flow and heat transfer in the air gap behind photovoltaic panels , 1998 .

[13]  H.X. Yang,et al.  Validated simulation for thermal regulation of photovoltaic wall structures , 1996, Conference Record of the Twenty Fifth IEEE Photovoltaic Specialists Conference - 1996.

[14]  Bjarne W. Olesen,et al.  Sustainable Heating, Cooling and Ventilation of a Plus-Energy House via Photovoltaic/Thermal Panels , 2014 .

[15]  O. Dupré,et al.  Optimizations of photovoltaic cells including the minimization of internal heat sources , 2014 .

[16]  Michaël Kummert,et al.  A novel approach to compare building-integrated photovoltaics/thermal air collectors to side-by-side PV modules and solar thermal collectors , 2014 .

[17]  M. Sandberg,et al.  Investigation of fluid flow and heat transfer in a vertical channel heated from one side by PV elements, part II - Experimental study , 1996 .

[18]  Guohui Gan,et al.  Effect of air gap on the performance of building-integrated photovoltaics , 2009 .