Plasma flow reactor for steady state monitoring of physical and chemical processes at high temperatures.

We present the development of a steady state plasma flow reactor to investigate gas phase physical and chemical processes that occur at high temperature (1000 < T < 5000 K) and atmospheric pressure. The reactor consists of a glass tube that is attached to an inductively coupled argon plasma generator via an adaptor (ring flow injector). We have modeled the system using computational fluid dynamics simulations that are bounded by measured temperatures. In situ line-of-sight optical emission and absorption spectroscopy have been used to determine the structures and concentrations of molecules formed during rapid cooling of reactants after they pass through the plasma. Emission spectroscopy also enables us to determine the temperatures at which these dynamic processes occur. A sample collection probe inserted from the open end of the reactor is used to collect condensed materials and analyze them ex situ using electron microscopy. The preliminary results of two separate investigations involving the condensation of metal oxides and chemical kinetics of high-temperature gas reactions are discussed.

[1]  Subith S. Vasu,et al.  Shock tube ignition delay times and methane time-histories measurements during excess CO2 diluted oxy-methane combustion , 2016 .

[2]  Y. Groisman,et al.  Boron- and iron-bearing molecules in laser-induced plasma , 2015 .

[3]  J. Hornkohl,et al.  Computation of diatomic molecular spectra for selected transitions of aluminum monoxide, cyanide, diatomic carbon, and titanium monoxide , 2015 .

[4]  V. Motto-Ros,et al.  Investigation of local thermodynamic equilibrium in laser-induced plasmas: Measurements of rotational and excitation temperatures at long time scales , 2014 .

[5]  Sangeeta B. Punjabi,et al.  Flow and temperature patterns in an inductively coupled plasma reactor: Experimental measurements and CFD simulations , 2014 .

[6]  R. Hanson,et al.  Recent advances in laser absorption and shock tube methods for studies of combustion chemistry , 2014 .

[7]  Ronald K. Hanson,et al.  Laser absorption diagnostic for measuring acetylene concentrations in shock tubes , 2014 .

[8]  V. Linss,et al.  Gas temperature determination from rotational lines in non-equilibrium plasmas: a review , 2014 .

[9]  Valery Godyak,et al.  Ferromagnetic enhanced inductive plasma sources , 2012 .

[10]  J. Hornkohl,et al.  Computation of AlO B2Σ+ → X2Σ+ emission spectra. , 2011, Spectrochimica acta. Part A, Molecular and biomolecular spectroscopy.

[11]  B. Simard,et al.  Synthesis of single-walled carbon nanotubes by induction thermal plasma , 2009 .

[12]  J. Menart,et al.  Net emission coefficients for argon-iron thermal plasmas , 2002 .

[13]  E. Pfender,et al.  Critical analysis of viscosity data of thermal argon plasmas at atmospheric pressure , 1996 .

[14]  M. Calzada,et al.  On the use of the line-to-continuum intensity ratio for determining the electron temperature in a high-pressure argon surface-microwave discharge , 1995 .

[15]  J. Hornkohl,et al.  Spectroscopic temperature measurements in a decaying laser-induced plasma using the C2 Swan system , 1994 .

[16]  S. Johansson,et al.  A New Multiplet Table for Fe , 1994, astro-ph/9404049.

[17]  M. Cappelli,et al.  High growth rate diamond synthesis in a large area atmospheric pressure inductively coupled plasma , 1990 .

[18]  Keiichi Mito,et al.  Determination of the thermal conductivity of argon and nitrogen over a wide temperature range through data evaluation and shock-tube experiments , 1986 .

[19]  M. Boulos.  The inductively coupled R.F. (radio frequency) plasma , 1985 .

[20]  M. Shallis,et al.  Precision measurement of relative oscillator strengths – VIII. Measures of Fe I transitions from levels a3F2–4 (1.49–1.61 eV) with an accuracy of 1 per cent , 1979 .

[21]  H. Griem.  High-Density Corrections in Plasma Spectroscopy , 1962 .

[22]  Christina Kluge,et al.  Data Reduction And Error Analysis For The Physical Sciences , 2016 .