Study & Analysis of Dc to Dc Converter Using Simulink

Every Electronic circuit is assumed to operate off some supply voltage which is usually assumed to be constant. A voltage regulator is a power electronic circuit that maintains a constant output voltage irrespective of change in load current or line voltage. Many different types of voltage regulators with a variety of control schemes are used. With the increase in circuit complexity and improved technology a more severe requirement for accurate and fast regulation is desired. This has led to need for newer and more reliable design of dc-dc converters. The dc-dc converter inputs an unregulated dc voltage input and outputs a constant or regulated voltage. The regulators can be mainly classified into linear and switching regulators. All regulators have a power transfer stage and a control circuitry to sense the output voltage and adjust the power transfer stage to maintain the constant output voltage.Since a feedback loop is necessary to maintain regulation, some type of compensation is required to maintain loop stability. Compensation techniques vary for different control schemes and a small signal analysis of system is necessary to design a stable compensation circuit. State space analysis is typically used to develop a small signal model of a converter and then depending on the type of control scheme used, the small signal model of converter is modified to facilitate the design of the compensation network. In contrast to a state space approach, PWM switch modeling develops a small signal of switching components of converterSystem level models are implemented using the Simulink in Mat lab. Thefollowing study provides details of methodologies for designing each component or block used in the switching regulator. Finally, simulation results are presented for voltage and V2 control schemes and their performance results are compared and inferences are drawnon the performance of current mode control. Keyword:Interleavers, iterative decoding, low-density parity-check codes, convolutional codes, turbo codes.

[1]  Ivo Barbi,et al.  The three-level ZVS-PWM DC-to-DC converter , 1993 .

[2]  Tsai-Fu Wu,et al.  A PDM controlled series resonant multi-level converter applied for X-ray generators , 1999, 30th Annual IEEE Power Electronics Specialists Conference. Record. (Cat. No.99CH36321).

[3]  S. Arulselvi,et al.  Design and simulation of model based controllers for quasi resonant converters using neural networks , 2006, 2006 India International Conference on Power Electronics.

[4]  G. Uma,et al.  A New Push-Pull Zero Voltage Switching Quasi-Resonant Converter: Topology, Analysis and Experimentation , 2005, 2005 Annual IEEE India Conference - Indicon.

[5]  S. Jalbrzykowski,et al.  Soft-switching full-bridge DC-DC current converter , 2007 .

[6]  Eun Soo Kim,et al.  A three level ZVZCS phase-shifted DC/DC converter using a tapped inductor and a snubber capacitor , 2001, APEC 2001. Sixteenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.01CH37181).

[7]  Chia-Wei Lee,et al.  A novel soft-switching full-bridge converter , 2009, 2009 International Conference on Power Electronics and Drive Systems (PEDS).

[8]  Ivo Barbi,et al.  DC/DC converter for high input voltage: four switches with peak voltage of V/sub in//2, capacitive turn-off snubbing and zero-voltage turn-on , 1998, PESC 98 Record. 29th Annual IEEE Power Electronics Specialists Conference (Cat. No.98CH36196).

[9]  Yoo-Ho Kim,et al.  An improved three level ZVZCS DC/DC converter using a tapped inductor and a snubber capacitor , 2002, Proceedings of the Power Conversion Conference-Osaka 2002 (Cat. No.02TH8579).

[10]  Fred C. Lee,et al.  A zero-voltage and zero-current switching three-level DC/DC converter , 2002 .