Tailoring microstructure and texture of annealed Al-Mn alloy through the variation of homogenization and prior cold deformation strain

[1]  R. Logé,et al.  The double-edge effect of second-phase particles on the recrystallization behaviour and associated mechanical properties of metallic materials , 2018 .

[2]  R. Logé,et al.  Controlling grain structure and texture in Al-Mn from the competition between precipitation and recrystallization , 2017 .

[3]  Dong Nyung Lee,et al.  Numerical analysis on the formation of P-orientation near coarse precipitates in FCC crystals during recrystallization , 2017 .

[4]  Qing Liu,et al.  Influence of pre-recovery on the subsequent recrystallization and mechanical properties of a twin-roll cast Al-Mn alloy , 2017 .

[5]  R. Logé,et al.  On the sluggish recrystallization of a cold-rolled Al–Mn–Fe–Si alloy , 2016, Journal of Materials Science.

[6]  Yanjun Li,et al.  Orientation Preference of Recrystallization in Supersaturated Aluminum Alloys Influenced by Concurrent Precipitation , 2016, Metallurgical and Materials Transactions A.

[7]  N. P. Gurao,et al.  Effect of crystallographic texture on precipitation induced anisotropy in an aluminium magnesium silicon alloy , 2015 .

[8]  K. Marthinsen,et al.  The effect of heating rate on the softening behaviour of a deformed Al-Mn alloy with strong and weak concurrent precipitation , 2015 .

[9]  Yanjun Li,et al.  Two-stage annealing of a cold-rolled Al–Mn–Fe–Si alloy with different microchemistry states , 2015 .

[10]  K. Marthinsen,et al.  Factors affecting the strength of P{011}〈566〉-texture after annealing of a cold-rolled Al–Mn–Fe–Si alloy , 2015, Journal of Materials Science.

[11]  L. Kestens,et al.  Evolution of recrystallization textures in particle containing Al alloys after various rolling reductions: Experimental study and modeling , 2015 .

[12]  Yan-jun Li,et al.  Isothermal annealing of cold-rolled Al−Mn−Fe−Si alloy with different microchemistry states , 2014 .

[13]  O. Engler,et al.  Microstructural Evolution during Isothermal Annealing of a Cold-Rolled Al-Mn-Fe-Si Alloy with Different Microchemistry States , 2014 .

[14]  Ning Wang,et al.  The influence of microchemistry on the softening behaviour of two cold-rolled Al–Mn–Fe–Si alloys , 2014 .

[15]  G. Fan,et al.  Oriented growth during recrystallization revisited in three dimensions , 2014 .

[16]  G. Gottstein,et al.  The origin and development of the P{011}<111> orientation during recrystallization of particle-containing alloys , 2011 .

[17]  E. Nes,et al.  Effect of Concurrent Precipitation on Recrystallization and Evolution of the P-Texture Component in a Commercial Al-Mn Alloy , 2010 .

[18]  N. Hansen,et al.  Evolution of Microstructure and Texture during Annealing of Aluminum AA1050 Cold Rolled to High and Ultrahigh Strains , 2010 .

[19]  G. Rohrer.  “Introduction to Grains, Phases, and Interfaces—an Interpretation of Microstructure,” Trans. AIME, 1948, vol. 175, pp. 15–51, by C.S. Smith , 2010 .

[20]  W. C. Liu,et al.  Effect of Rolling Reduction on the P$$ \left\{ {011} \right\}\left\langle {455} \right\rangle $$ Recrystallization Texture in a Supersaturated Al-Mn-Mg Alloy , 2009 .

[21]  T. Zhai,et al.  Effect of Precipitates on the Development of P Orientation {011}$$ \left\langle {566} \right\rangle $$ in a Recrystallized Continuous Cast AA 3004 Aluminum Alloy after Cold Rolling , 2009 .

[22]  W. C. Liu,et al.  Effect of heating rate on the microstructure and texture of continuous cast AA 3105 aluminum alloy , 2008 .

[23]  W. C. Liu,et al.  Evolution of recrystallization and recrystallization texture in continuous-cast AA 3015 aluminum alloy , 2005 .

[24]  Weimin Mao,et al.  A texture optimization study for minimum earing in aluminium by use of a texture component crystal plasticity finite element method , 2004 .

[25]  B. Hutchinson,et al.  Orientation dependence of secondary recrystallisation in silicon–iron , 2003 .

[26]  L. Arnberg,et al.  Quantitative study on the precipitation behavior of dispersoids in DC-cast AA3003 alloy during heating and homogenization , 2003 .

[27]  L. Arnberg,et al.  Evolution of eutectic intermetallic particles in DC-cast AA3003 alloy during heating and homogenization , 2003 .

[28]  F. J. Humphreys,et al.  Recrystallisation behaviour of supersaturated Al–Mn alloys Part 1 – Al–1.3 wt-%Mn , 2003 .

[29]  P. Yang,et al.  On the formation of recrystallization textures in binary Al-1.3% Mn investigated by means of local texture analysis , 1996 .

[30]  F. J. Humphreys,et al.  Grain boundary migration and Zener pinning in particle-containing copper crystals , 1996 .

[31]  O. Daaland,et al.  Recrystallization texture development in commercial AlMnMg alloys , 1996 .

[32]  D. J. Jensen,et al.  Growth rates and misorientation relationships between growing nuclei/grains and the surrounding deformed matrix during recrystallization , 1995 .

[33]  F. J. Humphreys,et al.  Recrystallization and Related Annealing Phenomena , 1995 .

[34]  K. Kawasaki,et al.  Dynamic Observation of the Growth of Secondary Recrystallized Grains of Fe-3% Si Alloy Utilizing Synchrotron X-Ray Topography , 1994 .

[35]  F. J. Humphreys.  The nucleation of recrystallization at second phase particles in deformed aluminium , 1977 .

[36]  I. Dillamore,et al.  The Mechanisms of Recrystallization in Cubic Metals with Particular Reference to Their Orientation-Dependence , 1974 .

[37]  Hsun Hu,et al.  The Orientation Dependence of the Rate of Grain Boundary Migration , 1950 .

[38]  R. Doherty,et al.  Effect of Heating Rate on Recrystallization of Twin Roll Cast Aluminum , 2008 .

[39]  R. Doherty.  Recrystallization and texture , 1997 .

[40]  D. Raabe,et al.  Selective particle drag during primary recrystallization of Fe-Cr alloys , 1992 .

[41]  O. Hunderi,et al.  On the Zener drag , 1985 .