论文信息 - Numerical simulation of roll forming for channel section with outer edge

Numerical simulation of roll forming for channel section with outer edge

The finite strip method in structural analysis has been extended, and elastic-plastic large deformation spline finite strip method based on the Updated-Lagrange method (U. L. method) was established to simulate roll forming process of channel section with outer edge. The deformation characteristics of strip was analyzed, and the three-dimensional displacement field, strain field and stress field of deformed strip were got. The calculation example proves that the peak transverse pressing membrane strain is on the corner part of the deformed strip, and the peak longitudinal stretching strain is on the outer edge part of the deformed strip in front of rolls. In addition, the transverse deformation of the deformed strip is principal, and the longitudinal deformation is small.

[1] S. M. Panton,et al. Longitudinal and shear strain development in cold roll forming , 1996 .

[2] Mustafa A. Ahmetoglu,et al. Computer aided simulation of cold roll forming — a computer program for simple section profiles , 1996 .

[3] R. J. Pick,et al. Developments in the geometric modelling of an ERW pipe skelp , 1991 .

[4] Taylan Altan,et al. Simulation of roll forming process with the 3-D FEM code PAM-STAMP , 1996 .

[5] P. Gilormini,et al. A simulation of cold-roll forming for elastoplastic materials , 1998 .

[6] Michel Brunet,et al. Modelling of a roll-forming process with a combined 2D and 3D FEM code , 1998 .

[7] Cai Liu,et al. Numerical simulation of roll-forming by B-spline finite strip method , 1996 .

[8] S. Thiruvarudchelvan,et al. The application of computational and experimental techniques to metal deformation in cold roll forming , 1994 .