Effects of tip gap and amplitude of piezoelectric fans on the performance of heat sinks in microelectronic cooling

Piezoelectric fan is a promising option for cooling microelectronic devices owing to its unique features such as no electromagnetic noise, low power consumption and minimum space requirement. The recent interest is to integrate the piezoelectric fans (piezofans) with heat sink; this idea is widely accepted and researches are still underway. This article presents experimental analysis on the effects of tip gap (δ) and amplitude of piezofan vibration (α) on the heat transfer characteristics of finned heat sinks. Two heat sink configurations, namely A and B (with two and four fins respectively) each of which is arranged with three piezofans, are considered for the study. The transient temperature distributions for cases with and without piezofans are obtained for both the configurations, and compared. The heat transfer coefficient, thermal impedance, Nusselt number and Reynolds number are investigated as functions of δ and α. The effect of α on the fan effectiveness is also analyzed. It is observed that the configuration B has better cooling performance compared to A. Among the tested ranges of δ and α, the case with least tip gap (δ = 0.03) and highest amplitude (α = 5.29) is found to be the best; at this setting, the fan effectiveness is increased to almost 4 times compared to the case without piezofans.

[1]  E. Koschmieder.  Taylor vortices between eccentric cylinders , 1976 .

[2]  Adrian Bejan,et al.  Heat sinks with sloped plate fins in natural and forced convection , 1996 .

[3]  S.V. Garimella,et al.  Piezoelectric Fans Using Higher Flexural Modes for Electronics Cooling Applications , 2007, IEEE Transactions on Components and Packaging Technologies.

[4]  R. Arularasan,et al.  CFD ANALYSIS IN A HEAT SINK FOR COOLING OF ELECTRONIC DEVICES , 2008 .

[5]  M. K. Abdullah,et al.  Numerical and experimental investigations on effect of fan height on the performance of piezoelectric fan in microelectronic cooling , 2009 .

[6]  Suresh V. Garimella,et al.  Local Heat Transfer Coefficients Induced by Piezoelectrically Actuated Vibrating Cantilevers , 2007 .

[7]  Wagner Enno,et al.  純FC‐84及びFC‐3284及びその二元混合物の核沸騰における高分解能測定 , 2009 .

[8]  C. P. Tso,et al.  3-D numerical analysis of natural convective liquid cooling of a 3×3 heater array in rectangular enclosures , 1999 .

[9]  Mark D. Semon,et al.  POSTUSE REVIEW: An Introduction to Error Analysis: The Study of Uncertainties in Physical Measurements , 1982 .

[10]  J. Petroski,et al.  Optimization of Piezoelectric Oscillating Fan-Cooled Heat Sinks for Electronics Cooling , 2010, IEEE Transactions on Components and Packaging Technologies.

[11]  M. Ohadi,et al.  Thermal management of harsh-environment electronics , 2004, Twentieth Annual IEEE Semiconductor Thermal Measurement and Management Symposium (IEEE Cat. No.04CH37545).

[12]  M. Mochizuki,et al.  Key challenges for the piezo technology with applications to low form factor thermal solutions , 2006, Thermal and Thermomechanical Proceedings 10th Intersociety Conference on Phenomena in Electronics Systems, 2006. ITHERM 2006..

[13]  Jong-Seok Rho,et al.  Optimal Design of Piezoelectric Cantilever Fan by Three-Dimensional Finite Element Analysis , 2005 .

[14]  Y. J. Lee.  Thermo-mechanical properties of high performance thermal interface gap filler pads , 2010, ITherm 2010.

[15]  S. Garimella,et al.  Experimental Investigation of the Thermal Performance of Piezoelectric Fans , 2004 .

[16]  Suresh V. Garimella,et al.  Analysis and Prediction of the Thermal Performance of Piezoelectrically Actuated Fans , 2009 .

[17]  S. Osaka,et al.  Vibrational fan using the piezoelectric polymer PVF2 , 1979, Proceedings of the IEEE.

[18]  Suresh V. Garimella,et al.  Advances in mesoscale thermal management technologies for microelectronics , 2006, Microelectron. J..

[19]  S.V. Garimella,et al.  An Experimental Study of Fluidic Coupling Between Multiple Piezoelectric Fans , 2006, Thermal and Thermomechanical Proceedings 10th Intersociety Conference on Phenomena in Electronics Systems, 2006. ITHERM 2006..

[20]  C. Bailey,et al.  Thermal Management Technologies for Electronic Packaging: Current Capabilities and Future Challenges for Modelling Tools , 2008, 2008 10th Electronics Packaging Technology Conference.

[21]  Suresh V. Garimella,et al.  Characterization and optimization of the thermal performance of miniature piezoelectric fans , 2007 .

[22]  M. A. Mujeebu,et al.  A CFD-based experimental analysis on the effect of free stream cooling on the performance of micro processor heat sinks , 2008 .

[23]  Arvind Raman,et al.  Hydrodynamic coupling between micomechanical beams osciallating in viscous fluids , 2007 .

[24]  S.V. Garimella,et al.  Pressure and Flow Rate Performance of Piezoelectric Fans , 2009, IEEE Transactions on Components and Packaging Technologies.

[25]  Y. Joshi,et al.  Three-Dimensional Study of Combined Conduction, Radiation, and Natural Convection From Discrete Heat Sources in a Horizontal Narrow-Aspect-Ratio Enclosure , 1999 .

[26]  Suresh V. Garimella,et al.  Cooling Performance of Arrays of Vibrating Cantilevers , 2009 .

[27]  A. Harnoy,et al.  Analysis of dynamic enhancement of natural convection cooling by a discrete vibrating plate , 2006 .

[28]  Y. Ooi,et al.  Effect of piezoelectric fan height on flow and heat transfer for electronics cooling applications , 2008, 2008 International Conference on Electronic Materials and Packaging.