Numerical simulation of pile installation

During installation of a displacement pile, the soil around the pile is heavily distorted. The resulting changes in soil density and stress state around the pile determine the ultimate pile capacity. In most finite element models, the installation phase is not explicitly modelled. In this paper the full installation phase is modelled in two different ways, in a numerical code capable of large deformations. In the first approach the pile is fixed and the soil flows around the pile. This modelling approach requires somewhat unrealistic boundary conditions and requires that the results for the pile installation are for a non-stationary phase of the calculation, whereas formally only the values at the stationary full penetration phase are reliable. A second modelling approach has been introduced to overcome these limitations. In the new approach the initial conditions are set as a stress level, increasing linearly with depth, resulting from a gravity loading stage, and a stepwise penetration of the pile into the soil is prescribed. This approach updates the geometry of the problem domain and keeps updating the convective terms in a fixed mesh. Results are compared with experimental results from centrifuge tests. Although both models show the development of large effective vertical stress below the pile base and porosity change near the pile shaft, also differences with the experimental results are found. Especially the stiffness response during pile installation is difficult to model correctly.

[1]  David White,et al.  Lateral stress changes and shaft friction for model displacement piles in sand , 2005 .

[2]  Brendan C. O'Kelly,et al.  Effect of friction fatigue on pile capacity in dense sand , 2007 .

[3]  Teruo Nakai,et al.  STRESS-DEFORMATION AND STRENGTH CHARACTERISTICS OF SOIL UNDER THREE DIFFERENT PRINCIPAL STRESSES , 1974 .

[4]  M. Randolph,et al.  A practical numerical approach for large deformation problems in soil , 1998 .

[5]  J. Tejchman,et al.  FE-studies on Shear Localization in an Anistropic Micro-polar Hypoplastic Granular Material , 2006 .

[6]  Barry Lehane,et al.  Mechanisms of Shaft Friction in Sand from Instrumented Pile Tests , 1994 .

[7]  J. Huetink.  On the simulation of thermo-mechanical forming processes , 1986 .

[8]  M. Wehnert,et al.  Numerical analyses of load tests on bored piles , 2004 .

[9]  David White,et al.  An investigation into the behaviour of pressed-in piles , 2002 .

[10]  Roman D. Hryciw,et al.  Large displacement FEM modelling of the cone penetration test (CPT) in normally consolidated sand , 2003 .

[11]  I. Herle,et al.  Hypoplastic model for cohesionless soils with elastic strain range , 1997 .

[12]  Hendrik Sturm,et al.  AN INVESTIGATION OF THE TIP RESISTANCE IN GRANULAR AND SOFT SOILS DURING STATIC, ALTERNATING AND DYNAMIC PENETRATION , 2006 .

[13]  G. Gudehus.  A COMPREHENSIVE CONSTITUTIVE EQUATION FOR GRANULAR MATERIALS , 1996 .

[14]  Peter Wriggers,et al.  Finite element analysis of pile installation using large-slip frictional contact , 2005 .

[15]  P. V. Wolffersdorff,et al.  A hypoplastic relation for granular materials with a predefined limit state surface , 1996 .

[16]  Han Huetink,et al.  An Eulerean finite element model for penetration in layered soil , 1996 .

[17]  David White,et al.  Drum centrifuge modelling of displacement piles in sand: data report , 2003 .

[18]  Wout Broere,et al.  Modelling the bearing capacity of displacement piles in sand , 2006 .

[19]  Mohammad Mehdi Ahmadi,et al.  Cone tip resistance in sand: modeling, verification, and applications , 2005 .

[20]  Mark Randolph,et al.  SCIENCE AND EMPIRICISM IN PILE FOUNDATION DESIGN , 2003 .

[21]  T. Hughes,et al.  Streamline upwind/Petrov-Galerkin formulations for convection dominated flows with particular emphasis on the incompressible Navier-Stokes equations , 1990 .

[22]  D. Wood.  Soil Behaviour and Critical State Soil Mechanics , 1991 .

[23]  Matthew Richard Coop,et al.  An investigation of the effect of soil state on the capacity of driven piles in sands , 2001 .

[24]  P. van den Berg,et al.  Analysis of Soil Penetration , 1994 .

[25]  Gerd Gudehus,et al.  Determination of parameters of a hypoplastic constitutive model from properties of grain assemblies , 1999 .

[26]  Stefan Van Baars,et al.  Numerical Modelling of Tension Piles , 1999 .

[27]  Roger Frank,et al.  Axisymmetric finite element analysis of pile loading tests , 2009 .

[28]  Mohamed S. Gadala,et al.  Recent trends in ALE formulation and its applications in solid mechanics , 2004 .

[29]  Jürgen Grabe,et al.  Finite‐Elemente‐Analyse zur Vibrationsrammung von Pfählen , 2005 .