Ultrawideband microwave-radar conceptual design

This paper outlines the special considerations that characterize the design of an UWB radar for the detection of low-altitude missiles over the sea. It discusses the factors which enter into the choice of frequency, and the selection of the transmitter, antenna, and receiver. Reviewed are signal processing issues concerning detection of UWB signals in noise and clutter, nondoppler MTI based on the pulse-to-pulse change in range due to target motion, measurement of target height based on multipath time delay, and target recognition. As the investigation progressed, the authors became disappointed with the available UWB technology, but encouraged about the potential advantages of UWB for this application. The chief limitation of UWB radar that must be overcome before applications are viable is its poor electromagnetic compatibility (EMC). >

[1]  Jeffrey A. Oicles,et al.  High-power waveform generation using photoconductive switches , 1991, Other Conferences.

[2]  Alfonso Farina,et al.  Detection with high resolution radar - Great promise, big challenge , 1991 .

[3]  P.K. Hughes,et al.  A High-Resolution Radar Detection Strategy , 1983, IEEE Transactions on Aerospace and Electronic Systems.

[4]  G. Spek Detection of a Distributed Target , 1971 .

[5]  R. H. Abrams The Microwave Power Module: a 'supercomponent' for radar transmitters , 1994, Proceedings of 1994 IEEE National Radar Conference.

[6]  William J. Caputi,et al.  Stretch: A Time-Transformation Technique , 1971, IEEE Transactions on Aerospace and Electronic Systems.