Vortex structures and heat transfer in a wall-bounded pin matrix: LES with a RANS wall-treatment

Abstract A hybrid LES/RANS simulation is applied to study the velocity, vorticity and thermal fields in flow over a staggered matrix of cylindrical pins bounded by a cold and a heated plane endwall approximating the typical configuration of internal cooling of gas-turbine blades. The hybrid approach considered is in fact a coarse-grid conventional LES coupled with the elliptic relaxation ζ – f RANS model that prevails in the wall-adjacent regions. Two Reynolds numbers have been considered, 10.000 and 30.000, based on the pin diameter and mean velocity between the two pins. First the performance of the hybrid approach was evaluated in comparison with the earlier reported URANS using the same RANS model throughout the whole flow, as well as with wall-resolved LES. The results of the hybrid method, found to recover with acceptable accuracy the dominant large-scale vortical patterns and the averaged flow parameters, were then used to analyse the effects of vortex structures on the velocity and thermal fields and their role in wall heat transfer using graphical visualisation. In addition to the temperature contours, the thermal field is also visualized by heat-flux lines, which make it possible to identify heat “corridors” and distinguish regions dominated by stochastic turbulent transport and those of large-scale vortical convection.

[1]  P. Durbin.  Near-wall turbulence closure modeling without “damping functions” , 1991, Theoretical and Computational Fluid Dynamics.

[2]  Lindsay A. Klennert,et al.  Endwall Heat Transfer Measurements in a Staggered Pin Fin Array With an Adiabatic Pin , 2007 .

[3]  Kemal Hanjalic,et al.  Will RANS Survive LES? A View of Perspectives , 2005 .

[4]  K. Hanjalic,et al.  Large-eddy simulations of tip leakage and secondary flows in an axial compressor cascade using a near-wall turbulence model , 2009 .

[5]  L. Temmerman,et al.  A hybrid two-layer URANS–LES approach for large eddy simulation at high Reynolds numbers , 2005 .

[6]  Giovanni Delibra,et al.  LES of flow and heat transfer in a channel with a staggered cylindrical pin matrix , 2008 .

[7]  B. Ni,et al.  Unstructured Large Eddy And Conjugate HeatTransfer Simulations Of Wall-bounded Flows , 2005 .

[8]  Javier Jiménez,et al.  Scaling of the velocity fluctuations in turbulent channels up to Reτ=2003 , 2006 .

[9]  Forrest E. Ames,et al.  Turbulent Augmentation of Internal Convection Over Pins in Staggered Pin Fin Arrays , 2004 .

[10]  M. Hadžiabdić,et al.  LES, RANS and combined simulation of impinging flows and heat transfer , 2006 .

[11]  S. Benhamadouche,et al.  LES, coarse LES, and transient RANS comparisons on the flow across a tube bundle , 2003 .

[12]  V. A. F. Costa,et al.  Bejan’s Heatlines and Masslines for Convection Visualization and Analysis , 2006 .

[13]  Forrest E. Ames,et al.  Turbulent Transport in Pin Fin Arrays: Experimental Data and Predictions , 2005 .

[14]  Michael A. Leschziner,et al.  Merging LES and RANS Strategies: Zonal or Seamless Coupling? , 2004 .

[15]  M. Hadžiabdić,et al.  A robust near-wall elliptic-relaxation eddy-viscosity turbulence model for CFD , 2004 .

[16]  B. Geurts,et al.  Direct and large-eddy simulation IV , 2001 .

[17]  K. Hanjalic,et al.  URANS of flow and endwall heat transfer in a pinned passage relevant to gas-turbine blade cooling , 2009 .