Fabrication and characterization of piezoelectric micromachined ultrasonic transducers with thick composite PZT films.

Ferroelectric microelectromechanical systems (MEMS) has been a growing area of research in past decades, in which ferroelectric films are combined with silicon technology for a variety of applications, such as piezo-electric micromachined ultrasonic transducers (pMUTs), which represent a new approach to ultrasound detection and generation. For ultrasound-radiating applications, thicker PZT films are preferred because generative force and response speed of the diaphragm-type transducers increase with increasing film thickness. However, integration of 4- to 20-microm thick PZT films on silicon wafer, either the deposition or the patterning, is still a bottleneck in the micromachining process. This paper reports on a diaphragm-type pMUT. A composite coating technique based on chemical solution deposition and high-energy ball milled powder has been used to fabricate thick PZT films. Micromachining of the pMUTs using such thick films has been investigated. The fabricated pMUT with crack-free PZT films up to 7-microm thick was evaluated as an ultrasonic transmitter. The generated sound pressure level of up to 120 dB indicates that the fabricated pMUT has very good ultrasound-radiating performance and, therefore, can be used to compose pMUT arrays for generating ultrasound beam with high directivity in numerous applications. The pMUT arrays also have been demonstrated.

[1]  H. Hng,et al.  Low Temperature Processing of Nanocrystalline Lead Zirconate Titanate (PZT) Thick Films and Ceramics by a Modified Sol-Gel Route , 2002 .

[2]  Jun Akedo,et al.  Piezoelectric properties and poling effect of Pb(Zr, Ti)O3 thick films prepared for microactuators by aerosol deposition , 2000 .

[3]  M. Sayer,et al.  Macroscopic Actuators Using Thick Piezoelectric Coatings , 2000 .

[4]  U. Schnakenberg,et al.  PZT thin films for piezoelectric microactuator applications , 2002 .

[5]  Jong-Uk Bu,et al.  Calibration of Non Linear Properties of Pb(Zr, Ti)O3 Cantilever Using Integrated Piezoresistive Sensor for High Speed Atomic Force Microscopy , 2002 .

[6]  J. Baborowski,et al.  PZT coated membrane structures for micromachined ultrasonic transducers , 2002, Proceedings of the 13th IEEE International Symposium on Applications of Ferroelectrics, 2002. ISAF 2002..

[7]  S. J. Milne,et al.  Characterization of sol-gel Pb(Zr_0.53Ti_0.47)O_3 films in the thickness range 0.25–10 μm , 1999 .

[8]  D. A. Barrow,et al.  Characterization of thick lead zirconate titanate films fabricated using a new sol gel based process , 1997 .

[9]  Zhihong Wang,et al.  Dense PZT thick films derived from sol-gel based nanocomposite process , 2003 .

[10]  Takashi Iijima,et al.  Preparation of Lead Zirconate Titanate Thick Films by Arc-Discharged Reactive Ion-Plating Method , 2001 .

[11]  J. Akedo,et al.  Actuation Properties of Lead Zirconate Titanate Thick Films Structured on Si Membrane by the Aerosol Deposition Method , 2000 .

[12]  T. Ren,et al.  A novel ferroelectric based microphone , 2003 .

[13]  T. Iijima,et al.  Preparation of Texture-Controlled Lead Zirconate Titanate Diaphragm-Type Film Actuator Using a Chemical Solution Method , 2001 .

[14]  Nava Setter,et al.  Interferometric measurements of electric field-induced displacements in piezoelectric thin films , 1996 .

[15]  Seiji Aoyagi,et al.  Arrayed ultrasonic microsensors with high directivity for in-air use using PZT thin film on silicon diaphragms ☆ , 2002 .

[16]  Leslie E. Cross,et al.  A sensitive double beam laser interferometer for studying high-frequency piezoelectric and electrostrictive strains , 1989 .

[17]  J. Akedo,et al.  Influence of Carrier Gas Conditions on Electrical and Optical Properties of Pb(Zr, Ti)O3 Thin Films Prepared by Aerosol Deposition Method , 2001 .

[18]  Masayuki Yamane,et al.  Preparation of Pb(Zr0.53Ti0.47)O3 Thick Films by an Interfacial Polymerization Method on Silicon Substrates and Their Electric and Piezoelectric Properties , 2000 .