Anomalous Concentrations of Seismically Triggered Rock Falls in Pacoima Canyon: Are They Caused by Highly Susceptible Slopes or Local Amplification of Seismic Shaking?

Anomalously high concentrations of rock falls were triggered in Pacoima Canyon (Los Angeles, California) during the 1994 Northridge earthquake. Similar concentrations were also documented from the 1971 San Fernando earthquake. Using an engineering rock-mass classification that evaluates the susceptibility of rock slopes to seismic failure based on the fracture properties of a rock mass (in terms of a numerical “ Q -value” that describes rock quality), the rock slopes in Pacoima Canyon were compared with rock slopes in surrounding areas where topography and lithology are similar, but rock-fall concentrations from the earthquakes were much lower. A statistical comparison of Q -values from five sites surrounding Pacoima Canyon indicates that seismic susceptibilities are similar to those within Pacoima Canyon; differences in the characteristics of rock slopes between these sites are not sufficient to account for the relatively high concentrations of rock falls within Pacoima Canyon as compared to low concentrations elsewhere. By eliminating susceptibility differences as a cause, the most likely explanation for the differences in rock-fall concentrations is anomalously high shaking levels in Pacoima Canyon, possibly resulting from topographic amplification within the canyon. Manuscript received 21 May 2001.

[1]  Stephen H. Hartzell,et al.  Initial investigation of site and topographic effects at Robinwood Ridge, California , 1994, Bulletin of the Seismological Society of America.

[2]  P. C. Jennings,et al.  Effects of canyon topography on strong ground motion , 1975 .

[3]  Charles S. Mueller,et al.  Source parameters of the 1980 Mammoth Lakes, California, earthquake sequence , 1982 .

[4]  Mehmet Çelebi,et al.  Topographical and geological amplifications determined from strong-motion and aftershock records of the 3 March 1985 Chile earthquake , 1987 .

[5]  David M. Boore,et al.  The effect of simple topography on seismic waves: Implications for the accelerations recorded at Pacoima Dam, San Fernando Valley, California , 1973, Bulletin of the Seismological Society of America.

[6]  L. R. West,et al.  Observed effects of topography on ground motion , 1973, Bulletin of the Seismological Society of America.

[7]  W. Ellsworth,et al.  The Coalinga, California, earthquake of May 2, 1983 , 1990 .

[8]  Nick Barton,et al.  Engineering classification of rock masses for the design of tunnel support , 1974 .

[9]  Thomas H. Heaton,et al.  A dislocation model of the 1994 Northridge, California, earthquake determined from strong ground motions , 1994 .

[10]  E. Harp,et al.  Landslides triggered by the earthquake , 1990 .

[11]  E. Harp,et al.  Inventory of landslides triggered by the 1994 Northridge, California earthquake , 1995 .

[12]  Randall W. Jibson,et al.  Inventory of landslides triggered by the 1994 Northridge, California earthquake , 1995 .

[13]  Michel Bouchon,et al.  Effect of topography on surface motion , 1973, Bulletin of the Seismological Society of America.

[14]  D. Boore.  A note on the effect of simple topography on seismic SH waves , 1972, Bulletin of the Seismological Society of America.

[15]  James N. Brune,et al.  Foam rubber modeling of topographic and Dam interaction effects at Pacoima Dam , 1989 .

[16]  Landslides from the May 25-27, 1980, Mammoth Lakes, California, earthquake sequence , 1984 .

[17]  D. Keefer.  Landslides caused by earthquakes , 1984 .

[18]  G. Wieczorek,et al.  Landslides from the February 4, 1976, Guatemala earthquake , 1981 .

[19]  A. Shakal,et al.  CSMP strong-motion records from the Northridge, California Earthquake of 17 January 1994 , 1994 .

[20]  E. Harp,et al.  An engineering rock classification to evaluate seismic rock-fall susceptibility and its application to the Wasatch Front , 1993 .