Creation of embedded structures in SU-8

Two methods were investigated for the creation of encapsulated micro-fluidic channels and bridges in negative tone SU-8 photoresist. The first uses two exposures at different wavelengths to create the channel sidewalls and microchannel encapsulation layer; the other method creates both using a single I-line (365 nm) exposure and a grayscale photomask. These methods can define structures with vertical dimensions ranging to hundreds of microns and introduces very little extra processing complexity. For the dual wavelength method, an I-line light source is used to define the channel walls while a non-collimated deep-UV (254 nm) light source provides a large energy dose to the top surface of the SU-8 to produce a membrane over all the channels. Using the dual wavelength method allows SU-8 to be used as the material for the channels and the encapsulation method is self-limiting avoiding the requirement for precise control over the exposure dose. The rate of UV dose and the post-exposure baking parameters are critical to the quality and strength of the micro-channels. Properly designed channels have been successfully developed in lengths up to 1 cm. Alternatively using a grayscale Zn/Al bimetallic photomask and a single I-line exposure, 3D bridge micro-structures were successfully made on SU-8. The use of grayscale masks for both techniques also provides the possibility of shaping the channel. With the ability to create micro-bridges, further research will be performed to investigate how well the single exposure technique can be used to produce micro-channels of various sizes and dimensions.

[1]  David Paul Steenson,et al.  Microfabrication of channels using an embedded mask in negative resist , 2001 .

[2]  Francis E. H. Tay,et al.  A novel micro-machining method for the fabrication of thick-film SU-8 embedded micro-channels , 2001 .

[3]  L.J. Guerin,et al.  Simple and low cost fabrication of embedded micro-channels by using a new thick-film photoplastic , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[4]  Lionel Buchaillot,et al.  Variation of absorption coefficient and determination of critical dose of SU-8 at 365 nm , 2006 .

[5]  C. Fu,et al.  A novel and simple fabrication method of embedded SU-8 micro channels by direct UV lithography , 2006 .

[6]  Glenn H. Chapman,et al.  Creating precise 3D microstructures using laser direct-write bimetallic thermal resist grayscale photomasks , 2005, SPIE LASE.

[7]  Wei-Keng Lin,et al.  A novel fabrication method of embedded micro-channels by using SU-8 thick-film photoresists , 2003 .

[8]  Glenn H. Chapman,et al.  Enhanced inorganic bimetallic thermal resists transparency and resolution for photomask fabrication , 2005, SPIE Advanced Lithography.

[9]  Bonnie L. Gray,et al.  Mechanically assembled polymer interconnects with dead volume analysis for microfluidic systems , 2007, SPIE MOEMS-MEMS.

[10]  M. Despont,et al.  SU-8: a low-cost negative resist for MEMS , 1997 .

[11]  F J Blanco,et al.  Fabrication of SU-8 multilayer microstructures based on successive CMOS compatible adhesive bonding and releasing steps. , 2005, Lab on a chip.

[12]  Glenn H. Chapman,et al.  Calibrating grayscale direct write bimetallic photomasks to create 3D photoresist structures , 2004, SPIE Photomask Technology.