A robust micro conveyer realized by arrayed polyimide joint actuators1A robust micro conveyer realiz

A new micro-robotic conveyance system based on arrays of movable robust silicon legs has been developed and investigated. Motion is achieved by thermal expansion in polyimide joint actuators using electrical heating. Successful experiments on moving and rotating flat objects in the millimeter range have been performed with high load capacity. The conveyer consists of a 15×5 mm2 chip having 12 silicon legs, each with a length of 500 µm. The maximum load conveyed on the structure was 3500 mg. Both transverse and rotational movements have been demonstrated experimentally. Conveyance velocities up to 12 mm s-1 have been measured. Accelerated lifetime measurements demonstrate the long-term stability of the actuators. The functionality of the polyimide joint actuators is unaffected after more than 2×108 load cycles.

[1]  R. Y. Webb,et al.  Micromachined microdevices and microinstruments , 1996 .

[2]  Paolo Dario,et al.  Microactuators for microrobots: a critical survey , 1992 .

[3]  Göran Stemme.  A CMOS integrated silicon gas-flow sensor with pulse-modulated output , 1988 .

[4]  Mark G. Allen,et al.  Movable micromachined silicon plates with integrated position sensing , 1990 .

[5]  S. Timoshenko,et al.  Analysis of Bi-Metal Thermostats , 1925 .

[6]  Chang-Jin Kim,et al.  Pneumatically driven microcage for micro-objects in biological liquid , 1999, Technical Digest. IEEE International MEMS 99 Conference. Twelfth IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.99CH36291).

[7]  Elisabeth Smela,et al.  Electrochemically driven polypyrrole bilayers for moving and positioning bulk micromachined silicon plates , 1999 .

[8]  G. Stemme,et al.  Three dimensional silicon triple-hot-wire anemometer based on polyimide joints , 1998, Proceedings MEMS 98. IEEE. Eleventh Annual International Workshop on Micro Electro Mechanical Systems. An Investigation of Micro Structures, Sensors, Actuators, Machines and Systems (Cat. No.98CH36176.

[9]  Gregory T. A. Kovacs,et al.  Computational methods for design and control of MEMS micromanipulator arrays , 1997 .

[10]  Masayoshi Esashi,et al.  A multilink active catheter with polyimide-based integrated CMOS interface circuits , 1999 .

[11]  G. Stemme,et al.  New small radius joints based on thermal shrinkage of polyimide in V-grooves for robust self-assembly 3D microstructures , 1998 .

[12]  P. Renaud,et al.  Thermally actuated optical microscanner with large angle and low consumption , 1999 .

[13]  Isao Shimoyama,et al.  Scaling in microrobots , 1995, Proceedings 1995 IEEE/RSJ International Conference on Intelligent Robots and Systems. Human Robot Interaction and Cooperative Robots.

[14]  Hiroyuki Fujita,et al.  A conveyance system using air flow based on the concept of distributed micro motion systems , 1994 .

[15]  Maria Chiara Carrozza,et al.  A microrobotic system for colonoscopy , 1997, Proceedings of International Conference on Robotics and Automation.

[16]  G. Stemme,et al.  Dynamic actuation of polyimide V-groove joints by electrical heating , 1998 .

[17]  Y.C. Lee,et al.  Prototype microrobots for micro positioning in a manufacturing process and micro unmanned vehicles , 1999, Technical Digest. IEEE International MEMS 99 Conference. Twelfth IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.99CH36291).

[18]  J. M. Noworolski,et al.  Microassembly technologies for MEMS , 1998, Photonics West - Micro and Nano Fabricated Electromechanical and Optical Components.

[19]  H. Fujita,et al.  Fabrication and testing of a micro superconducting actuator using the Meissner effect , 1990, IEEE Proceedings on Micro Electro Mechanical Systems, An Investigation of Micro Structures, Sensors, Actuators, Machines and Robots..

[20]  M. Allen,et al.  Design and fabrication of movable silicon plates suspended by flexible supports , 1989, IEEE Micro Electro Mechanical Systems, , Proceedings, 'An Investigation of Micro Structures, Sensors, Actuators, Machines and Robots'.

[21]  N. C. MacDonald,et al.  Single-crystal silicon actuator arrays for micro manipulation tasks , 1996, Proceedings of Ninth International Workshop on Micro Electromechanical Systems.

[22]  Gregory T. A. Kovacs,et al.  Organic thermal and electrostatic ciliary microactuator array for object manipulation , 1997 .

[23]  I. Shimoyama,et al.  Three dimensional SMA microelectrodes with clipping structure for insect neural recording , 1999, Technical Digest. IEEE International MEMS 99 Conference. Twelfth IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.99CH36291).

[24]  S. Zill,et al.  Exoskeletal sensors for walking , 1996 .

[25]  K. Pister,et al.  A planar air levitated electrostatic actuator system , 1990, IEEE Proceedings on Micro Electro Mechanical Systems, An Investigation of Micro Structures, Sensors, Actuators, Machines and Robots..

[26]  Koichi Suzumori,et al.  Micro inspection robot for 1-in pipes , 1999 .

[27]  Ulrich Rembold,et al.  An automated microrobot-based desktop station for micro assembly and handling of micro-objects , 1996, Proceedings 1996 IEEE Conference on Emerging Technologies and Factory Automation. ETFA '96.

[28]  Y. Haga,et al.  Small diameter active catheter using shape memory alloy , 1998, Proceedings MEMS 98. IEEE. Eleventh Annual International Workshop on Micro Electro Mechanical Systems. An Investigation of Micro Structures, Sensors, Actuators, Machines and Systems (Cat. No.98CH36176.

[29]  Kristofer S. J. Pister,et al.  Surface-micromachined components for articulated microrobots , 1996 .

[30]  T. Hirano,et al.  Microfactories; new applications of micromachine technology to the manufacture of small products , 1997 .

[31]  Thomas Frank.  Two-axis electrodynamic micropositioning devices , 1998 .

[32]  Ken Goldberg,et al.  MEMS fixtures for handling and assembly of microparts , 1999, Photonics West - Micro and Nano Fabricated Electromechanical and Optical Components.

[33]  John W. Suh,et al.  CMOS integrated ciliary actuator array as a general-purpose micromanipulation tool for small objects , 1999 .

[34]  Hiroyuki Fujita,et al.  Fabrication and operation of polyimide bimorph actuators for a ciliary motion system , 1993 .

[35]  W. S. Trimmer,et al.  Actuators for micro robots , 1989, Proceedings, 1989 International Conference on Robotics and Automation.

[36]  T. Ebefors.  Three-dimensional microstructures based on polyimide joints , 1998 .

[37]  Ronald S. Fearing,et al.  Powering 3 Dimensional Microrobots: Power Density Limitations , 1998 .

[38]  T. Fukuda,et al.  Microrobot and applications , 1993, Proceedings of IEEE 2nd International Workshop on Emerging Technologies and Factory Automation (ETFA '93).