Propagation of Multiple Short-Length-Scale Stall Cells in an Axial Compressor Rotor

Evolution and structure of multiple stall cells with short-length-scale in an axial compressor rotor have been investigated experimentally. In a low-speed research compressor rotor tested, a short-length-scale stall cell appeared at first, but did not grow rapidly in size, unlike a so-called spike-type stall inception observed in many multistage compressors. Alternatively, the number of cells increased to a certain stable state (a mild stall state) under a fixed throttle condition. In the mild stall state the multiple stall cells, the size of which was on the same order of the inception cell (a few blade spacings), were rotating at 72 percent of rotor speed and at intervals of 4.8 blade spacings. With further throttling, a long-length-scale wave appeared overlapping the multiple short-length-scale waves, then developed to a deep stall state with a large cell. In order to capture the short-length-scale cells in the mild stall state, a so-called double phase-locked averaging technique has been developed, by which the flow field can be measured phase locked to both the rotor and the stall cell rotation. Then, time-dependent ensemble averages of the three-dimensional velocity components upstream and downstream of the rotor have been obtained with a slanted hot-wire, and the pressure distributions on the casing wall with high-response pressure transducers. By a physically plausible explanation for the experimental results, a model for the flow mechanism of the short-length-scale stall cell has been presented. The distinctive feature of the stall cell structure is on the separation vortex bubble with a leg traveling ahead of the rotor, with changing the blade in turn on which the vortex leg stands.

[1]  Shuji Tanaka,et al.  On the Partial Flow Rate Performance of Axial-Flow Compressor and Rotating Stall : 1 st Report, Influences of Hub-Tip Ratio and Stators , 1975 .

[2]  Masahiro Inoue,et al.  Measurement of Three Dimensional Flow Field behind on Impeller by Means of Periodic Multi-sampling with a Slanted Hot Wire , 1982 .

[3]  D. K. Das,et al.  An Experimental Study of Rotating Stall in a Multistage Axial-Flow Compressor , 1984 .

[4]  K. Mathioudakis,et al.  Development of Small Rotating Stall in a Single Stage Axial Compressor , 1985 .

[5]  F. Moore,et al.  A Theory of Post-Stall Transients in Axial Compression Systems: Part II—Application , 1986 .

[6]  F. Moore,et al.  A Theory of Post-Stall Transients in Axial Compression Systems: Part I—Development of Equations , 1986 .

[7]  Tom Hynes,et al.  Stall Inception in Axial Compressors , 1990 .

[8]  Alan H. Epstein,et al.  Rotating Waves as a Stall inception Indication in Axial Compressors , 1991 .

[9]  M. Farge.  Wavelet Transforms and their Applications to Turbulence , 1992 .

[10]  Ivor Day.  Stall inception in axial flow compressors , 1993 .

[11]  Masahiro Inoue,et al.  Pressure Fluctuation on Casing Wall of Isolated Axial Compressor Rotors at Low Flow Rate , 1993 .

[12]  Peter D. Silkowski.  Measurements of rotor stalling in a matched and a mismatched multistage compressor , 1995 .

[13]  H. E. Gallus,et al.  Rotating Stall in a Single-Stage Axial Flow Compressor , 1996 .

[14]  Masato Furukawa,et al.  Controlled-Endwall-Flow Blading for Multistage Axial Compressor Rotor , 1997 .

[15]  Ivor Day,et al.  A study of spike and modal stall phenomena in a low-speed axial compressor , 1997 .

[16]  Pierpaolo Puddu,et al.  3D FLOW FIELD MEASUREMENT AROUND A ROTATING STALL CELL , 1998 .

[17]  Edward M. Greitzer,et al.  1997 Best Paper Award—Controls and Diagnostics Committee: Active Stabilization of Rotating Stall and Surge in a Transonic Single-Stage Axial Compressor , 1998 .

[18]  Ivor Day,et al.  1997 Best Paper Award—Turbomachinery Committee: A Study of Spike and Modal Stall Phenomena in a Low-Speed Axial Compressor , 1998 .

[19]  A. P. Saxer,et al.  Prediction and Measurement of Rotating Stall Cells in an Axial Compressor , 1999 .

[20]  Ivor Day,et al.  Stall Inception and the Prospects for Active Control in Four High-Speed Compressors , 1997 .

[21]  Huu Duc Vo,et al.  Role of Blade Passage Flow Structurs in Axial Compressor Rotating Stall Inception , 1999 .