Preparation and Characterization of Microsphere ZnO ALD Coating Dedicated for the Fiber-Optic Refractive Index Sensor

We report the fabrication of a novel fiber-optic sensor device, based on the use of a microsphere conformally coated with a thin layer of zinc oxide (ZnO) by atomic layer deposition (ALD), and its use as a refractive index sensor. The microsphere was prepared on the tip of a single-mode optical fiber, on which a conformal ZnO thin film of 200 nm was deposited using an ALD process based on diethyl zinc (DEZ) and water at 100 °C. The modified fiber-optic microsphere was examined using scanning electron microscopy and Raman spectroscopy. Theoretical modeling has been carried out to assess the structure performance, and the performed experimental measurements carried out confirmed the enhanced sensing abilities when the microsphere was coated with a ZnO layer. The fabricated refractive index sensor was operating in a reflective mode of a Fabry–Pérot configuration, using a low coherent measurement system. The application of the ALD ZnO coating enabled for a better measurement of the refractive index of samples in the range of the refractive index allowed by the optical fiber. The proof-of-concept results presented in this work open prospects for the sensing community and will promote the use of fiber-optic sensing technologies.

[1]  M. Bechelany,et al.  Atomic layer deposition for biosensing applications. , 2018, Biosensors & bioelectronics.

[2]  Qiangzhou Rong,et al.  A high-sensitivity optical fiber relative humidity sensor based on microsphere WGM resonator , 2018, Optical Fiber Technology.

[3]  A. Julbe,et al.  Atomic Layer Deposition for Membranes: Basics, Challenges, and Opportunities , 2018, Chemistry of Materials.

[4]  M. Hirsch.  Fiber optic microsphere with ZnO thin film for potential application in refractive index sensor – theoretical study , 2018, Photonics Letters of Poland.

[5]  Xiaofei Zhao,et al.  In-situ growth of AuNPs on WS 2 @U-bent optical fiber for evanescent wave absorption sensor , 2018 .

[6]  I. Del Villar,et al.  Femtomolar Detection by Nanocoated Fiber Label-Free Biosensors. , 2018, ACS sensors.

[7]  Chenyang Lu,et al.  Wireless whispering-gallery-mode sensor for thermal sensing and aerial mapping , 2018, Light: Science & Applications.

[8]  M. Bechelany,et al.  Study of Cu 2 O\ZnO nanowires heterojunction designed by combining electrodeposition and atomic layer deposition , 2017 .

[9]  Rong Chen,et al.  Trace hydrogen sulfide gas sensor based on tungsten sulfide membrane-coated thin-core fiber modal interferometer , 2017 .

[10]  Sebastien Balme,et al.  ZnO films formed by atomic layer deposition as an optical biosensor platform for the detection of Grapevine virus A-type proteins. , 2017, Biosensors & bioelectronics.

[11]  F. Baldini,et al.  Biosensing with optical fiber gratings , 2017 .

[12]  Francesco Baldini,et al.  Towards a Uniform Metrological Assessment of Grating-Based Optical Fiber Sensors: From Refractometers to Biosensors , 2017, Biosensors.

[13]  Sebastien Balme,et al.  Boron Nitride Nanoporous Membranes with High Surface Charge by Atomic Layer Deposition. , 2017, ACS applied materials & interfaces.

[14]  Dnyandeo Pawar,et al.  ZnO coated Fabry-Perot interferometric optical fiber for detection of gasoline blend vapors: Refractive index and fringe visibility manipulation studies , 2017 .

[15]  Pawel Wierzba,et al.  Low-Coherence Interferometric Fiber-Optic Sensors with Potential Applications as Biosensors , 2017, Sensors.

[16]  M. Koba,et al.  Stack of Nano-Films on Optical Fiber End Face for Label-Free Bio-Recognition , 2016, Journal of Lightwave Technology.

[17]  Rumen Yordanov,et al.  Preparation and characterization of ALD deposited ZnO thin films studied for gas sensors , 2016 .

[18]  T. Pustelny,et al.  Influence of External Gaseous Environments on the Electrical Properties of ZnO Nanostructures Obtained by a Hydrothermal Method , 2016, Nanomaterials.

[19]  I. Iatsunskyi,et al.  Tuning of Structural and Optical Properties of Graphene/ZnO Nanolaminates , 2016 .

[20]  Jerzy Pluciński,et al.  Fiber optic Fabry-Pérot sensors: modeling versus measurements results , 2016, Integrated Optics.

[21]  Luís Coelho,et al.  Aptamer-based fiber sensor for thrombin detection , 2016, Journal of biomedical optics.

[22]  Pawel Wierzba,et al.  Application of Thin ZnO ALD Layers in Fiber-Optic Fabry-Pérot Sensing Interferometers , 2016, Sensors.

[23]  Ginu Rajan,et al.  Overview of Fiber Optic Sensor Technologies for Strain/Temperature Sensing Applications in Composite Materials , 2016, Sensors.

[24]  Tadeusz Pustelny,et al.  Optical investigations of ZnO layers affected by some selected gases in the aspect of their application in optical gas sensors , 2015 .

[25]  Arunas Ramanavicius,et al.  The influence of localized plasmons on the optical properties of Au/ZnO nanostructures , 2015 .

[26]  A. Julbe,et al.  Highly crystalline MOF-based materials grown on electrospun nanofibers. , 2015, Nanoscale.

[27]  Donats Erts,et al.  Tuning of ZnO 1D nanostructures by atomic layer deposition and electrospinning for optical gas sensor applications , 2015, Nanotechnology.

[28]  Minghong Yang,et al.  Dielectric multilayer-based fiber optic sensor enabling simultaneous measurement of humidity and temperature. , 2014, Optics express.

[29]  M. Srivastava,et al.  Influence of crystal size on the electron–phonon coupling in ZnO nanocrystals investigated by Raman spectroscopy , 2014 .

[30]  Kok-Sing Lim,et al.  Chronology of Fabry-Perot Interferometer Fiber-Optic Sensors and Their Applications: A Review , 2014, Sensors.

[31]  M. Androulidaki,et al.  Growth of ZnO nanolayers inside the capillaries of photonic crystal fibres , 2013, 1311.0373.

[32]  P. Déjardin,et al.  Slow translocation of polynucleotides and their discrimination by α-hemolysin inside a single track-etched nanopore designed by atomic layer deposition. , 2013, Nanoscale.

[33]  M. Ekielski,et al.  Hybrid photonics structures with grating and prism couplers based on ZnO waveguides , 2013 .

[34]  Won-Jae Lee,et al.  Effect of ALD surface treatment on structural and optical properties of ZnO nanorods , 2013 .

[35]  Miguel A. Pérez,et al.  Optical Fiber Sensors for Chemical and Biological Measurements , 2013 .

[36]  M. Verheijen,et al.  Supported Core/Shell Bimetallic Nanoparticles Synthesis by Atomic Layer Deposition , 2012 .

[37]  Andreas Waag,et al.  Zinc Oxide: From Fundamental Properties Towards Novel Applications , 2010 .

[38]  Z. Du,et al.  Analysis of Raman modes in Mn‐doped ZnO nanocrystals , 2009, 1009.2870.

[39]  H. Morkoç,et al.  Zinc Oxide: Fundamentals, Materials and Device Technology , 2009 .

[40]  Lalitkumar Bansal,et al.  Fiber Optic Sensors for Detection of Toxic and Biological Threats , 2007, Sensors.

[41]  Michael J. Callahan,et al.  Temperature dependence of Raman scattering in ZnO , 2007 .

[42]  H. Morkoç,et al.  A COMPREHENSIVE REVIEW OF ZNO MATERIALS AND DEVICES , 2005 .

[43]  David R. Walt,et al.  Polymer Modification of Fiber Optic Chemical Sensors as a Method of Enhancing Fluorescence Signal for pH Measurement , 1986 .

[44]  V. Tuchin,et al.  Nanolayers in Fiber-Optic Biosensing , 2018 .

[45]  D. Timotijević,et al.  Vibrational Spectroscopy of SOP Modes in ZnO Doped with CoO, MnO and Fe 2 O 3 , 2016 .

[46]  S. George.  Atomic layer deposition: an overview. , 2010, Chemical reviews.

[47]  S. Pearton,et al.  Zinc oxide bulk, thin films and nanostructures : processing, properties and applications , 2006 .

[48]  Ieee Microwave Theory,et al.  Quasioptical systems : Gaussian beam quasioptical propagation and applications , 1998 .