Decoupling control of three-phase shunt active power filter based on neural network inverse

This paper proposes a new control method for three-phase shunt active power filter (SAPF) by applying neural network inverse (NNI). The key of the proposed method is to decouple the SAPF system under the synchronous orthogonal d-q frame into two one-order linear subsystems, which concern the compensation current components. In addition, the linear closed-loop controllers are designed, respectively, for two compensation current components. Simulated results verify that by adopting the proposed method, the system has both good steady-state and dynamic performances. After the compensation, the total harmonic distortion (THD) of the power source currents in steady state is reduced from 25.57% to 1.23%.

[1]  Jinzhao Zhang,et al.  Experimental study on decoupling control of multi-motor synchronous based on an optimized neural network inverse , 2011, 2011 International Conference on Electrical and Control Engineering.

[2]  Paolo Mattavelli,et al.  High-performance hysteresis modulation technique for active filters , 1997 .

[3]  Kamal Al-Haddad,et al.  A review of active filters for power quality improvement , 1999, IEEE Trans. Ind. Electron..

[4]  Zhi Zhang,et al.  A Nonlinear Control Strategy for Shunt Active Power Filter , 2009, 2009 Asia-Pacific Power and Energy Engineering Conference.

[5]  Farhat Fnaiech,et al.  Nonlinear control technique to enhance dynamic performance of a shunt active power filter , 2003 .

[6]  Xianzhong Dai,et al.  Neural network inverse control of current-fed induction motor , 2008, 2008 IEEE International Symposium on Industrial Electronics.

[7]  Taotao Jin,et al.  Operation of One-Cycle Controlled Three-Phase Active Power Filter With Unbalanced Source and Load , 2006, IEEE Transactions on Power Electronics.

[8]  Zhilin Yang,et al.  The research of double-fed motor based on the neural network inverse system control strategy and it's simulation , 2011, 2011 IEEE 2nd International Conference on Computing, Control and Industrial Engineering.