Multi-Response Optimization of Al/GrCp10 MMC Performance in WEDM Using Integrated TOPSIS-ANFIS Approach

[1]  M. Phate,et al.  Modelling and investigating the impact of EDM parameters on surface roughness in EDM of Al/Cu/Ni Alloy , 2020, Australian Journal of Mechanical Engineering.

[2]  H. Nguyen,et al.  Optimizing process parameters in edm using low frequency vibration for material removal rate and surface roughness , 2020 .

[3]  Naresh Chakala,et al.  Optimisation of WEDM parameters on Nitinol alloy using RSM and desirability approach , 2019, Australian Journal of Mechanical Engineering.

[4]  P. Palanisamy,et al.  Clustered ANFIS weighing models for sweet lime (Citrus limetta) using computer vision system , 2019, Journal of Food Process Engineering.

[5]  Nguyen Thoi Trung,et al.  Developed comparative analysis of metaheuristic optimization algorithms for optimal active control of structures , 2019, Engineering with Computers.

[6]  P. Palanisamy,et al.  Classification and weighing of sweet lime (Citrus limetta) for packaging using computer vision system , 2019, Journal of Food Measurement and Characterization.

[7]  M. Phate,et al.  Modeling and prediction of WEDM performance parameters for Al/SiCp MMC using dimensional analysis and artificial neural network , 2019, Engineering Science and Technology, an International Journal.

[8]  M. Phate,et al.  Analysis of Machining Parameters in WEDM of Al/SiCp20 MMC Using Taguchi-Based Grey-Fuzzy Approach , 2019, Modelling and Simulation in Engineering.

[9]  Tej Singh,et al.  Experimental investigation and optimization of cobalt bonded tungsten carbide composite by hybrid AHP-TOPSIS approach , 2018, Alexandria Engineering Journal.

[10]  Ngoc-Vu Ngo,et al.  Application of TOPSIS to Taguchi method for multi-characteristic optimization of electrical discharge machining with titanium powder mixed into dielectric fluid , 2018, The International Journal of Advanced Manufacturing Technology.

[11]  Somvir Singh Nain,et al.  Performance evaluation of fuzzy-logic and BP-ANN methods for WEDM of aeronautics super alloy , 2018, MethodsX.

[12]  R. Jeyapaul,et al.  Optimisation of machining parameters on milling of GFRP composites by desirability function analysis using Taguchi method , 2018 .

[13]  Himadri Majumder,et al.  Prediction and optimization of surface roughness and micro-hardness using grnn and MOORA-fuzzy-a MCDM approach for nitinol in WEDM , 2018 .

[14]  P. Rao,et al.  Effect of wire EDM conditions on generation of residual stresses in machining of aluminum 2014 T6 alloy , 2016 .

[15]  A. Kumar,et al.  Effect of dielectric fluid with surfactant and graphite powder on Electrical Discharge Machining of titanium alloy using Taguchi method , 2015 .

[16]  Vinod Kumar,et al.  An experimental analysis and optimization of machining rate and surface characteristics in WEDM of Monel-400 using RSM and desirability approach , 2015 .

[17]  Chia-Chi Sun,et al.  A performance evaluation model by integrating fuzzy AHP and fuzzy TOPSIS methods , 2010, Expert Syst. Appl..

[18]  N. Senapati,et al.  Optimization of EDM process parameters for AlSiC- 20% SiC reinforced metal matrix composite with multi response using TOPSIS , 2017 .