Research and selection of MALE wing profile

Purpose The purpose of this research is a preliminary selection of wing section, which would be the best suited for PW-100 – a MALE class UAV of 600 kg weight. PW-100 will be used as a testing platform in different institutions such as research institutes, industry research centers or universities of technology (phase 1) to enable the in-flight testing of various on-board systems (mobile radars, thermovision sensors, chemical sensors, antennas, teledetection systems and others). Untypical layout of PW-100 resulted from the plans of further development of this configuration for a military application. Design/methodology/approach Important role in the research described in this paper plays the selection of main wing section to fulfil the preliminary requirements regarding maximum lift coefficient, minimum drag, aerodynamic efficiency etc. Two different wing sections (R1082 and SA19) were tested in wind tunnel, both with flaps deflected at the range of 0°-30°. Experimental measurements were performed in the low turbulence wind tunnel with closed test section of 45 cm × 35 cm. Numerical simulations of the flow around the wing sections were performed using MSES code. Boundary conditions were assumed basing on the typical mission of PW-100 for flight altitude around 9,000 m, speed of 110 km/h what results in Re = 956,000. Findings Lift coefficients obtained from both experimental and numerical methods for single slatted airfoil SA19 are much higher than that of get for Ronch R1082 airfoil. PW-100 aircraft with SA19 airfoils will be able to be trimmed and fly at any altitude up to 9,000 m and with an arbitrary weight up to 600 kg. Aerodynamic characteristics of SA19 remain smoother and more predictable than that of R1082 airfoil. The very promising properties of SA19 airfoil are well known to the authors since the beginning of last decade when PW team worked together with IAI team on CAPECON project and now it was fully confirmed by this research. Practical implications It was confirmed that selection of the proper wing section for the special mission performed by UAV is of the highest importance decision to be taken at the preliminary design phase. Because there is a limited access to the base of technical parameters in many different UAVs classes and the classical analysis of trends cannot be fully applied, the wing section analysis, either experimental or numerical, must be performed. The situation is much worse than in the case of manned aircrafts because most of the modern UAVs are made of carbon or glass fiber, and therefore, there is no chance for analysis of trends. Originality/value This paper presents a very efficient method of assessing the influence of wing section on aircraft performance adopted for MALE class UAV, especially in an early stage of preliminary design process. The assessment is built mainly on three requirements: Maximum 2D lift coefficient for take-off configuration with flap deflected on 20 degrees should be greater than 2.4. Endurance factor CL1.5/CD for loitering conditions (Ma = 0.5 and CD0 = 0.008) should be greater than 110. The relative wing section thickness should be greater/equal than 19 per cent (it is required for high volume fuel tank located in the wings).