论文信息 - Very thin torispherical pressure vessel ends under internal pressure: Strains, deformations, and buckling behaviour

Very thin torispherical pressure vessel ends under internal pressure: Strains, deformations, and buckling behaviour

Abstract Test results are presented for seventeen stainless steel torispherical pressure vessel ends, of production quality, loaded to failure under internal pressure. The nominal thickness/diameter ratios covered were 0.00237, 0.00158, and 0.0019, and the series included both ‘pressed and spun’ (eleven) and ‘crown and segment’ (six) ends. Details of the elastic, post-yield and buckling behaviour are given, and, where appropriate, predictions and relevant data from other sources are included for comparison. The full set of results is discussed in detail.

P Stanley | P. Stanley | T. Campbell | T D Campbell

[1] Jiro Adachi,et al. Buckling of torispherical shells under internal pressure , 1964 .

[2] S. S. Gill,et al. The failure of torispherical ends of pressure vessels due to instability and plastic deformation—An experimental investigation , 1975 .

[3] N. S. Barnett,et al. Private communication , 1969 .

[4] D. C. Drucker,et al. DESIGN OF THIN-WALLED TORISPHERICAL AND TORICONICAL PRESSURE VESSEL HEADS , 1961 .

[5] P Stanley,et al. Very thin torispherical pressure vessel ends under internal pressure: Test procedure and typical results , 1981 .

[6] H Fessler,et al. Stresses in torispherical drumheads: A critical evaluation , 1966 .

[7] S. S. Gill,et al. Experiments on the buckling under internal pressure of thin torispherical ends of cylindrical pressure vessels , 1978 .