Experimental study and pilot test of urea- and urea-and-foam-assisted steam flooding in heavy oil reservoirs

Abstract During steam flooding in heavy oil reservoirs, steam override and channeling often cause high residual oil saturation. To quantify and alleviate these phenomena, a 3-D experimental model for urea- and urea-and-foam-assisted steam flooding was designed and developed. Three comparative experiments were conducted to facilitate the identification of different effects of flooding, including conventional steam flooding (CSF). The system was switched to urea-assisted steam flooding (UASF) and to urea-and-foam-assisted steam flooding (UFASF). A comparison of specific parameters, including instantaneous oil-steam ratio (OSR), instantaneous watercut, difference in pressure between the inlet and outlet, and oil recovery, showed UFASF to be more effective than CSF or UASF with respect to flooding. As indicated by the change in temperature, the UFASF was able to control the steam override and channeling and fully extend the steam chamber effectively. This not only increased the sweep efficiency but also improved the conformance factor of the steam flooding. The experimental results of the UFASF were successfully used to guide a pilot test of the Jin-1 Block at Liaohe Oilfield, China. Results indicated that the UFASF may be a feasible means of improving the oil recovery of the steam flooding in heavy oil reservoirs.

[1]  David Ryan Espinosa,et al.  Nanoparticle-Stabilized Supercritical CO2 Foams for Potential Mobility Control Applications , 2010 .

[2]  Hon Chung Lau.  Alkaline Steam Foam: Concepts and Experimental Results , 2012 .

[3]  Tadeusz W Patzek,et al.  Field Applications of Steam Foam for Mobility Improvement and Profile Control , 1996 .

[4]  Margot Gerritsen,et al.  Improving Steam-Assisted Gravity Drainage Using Mobility Control Foams: Foam Assisted-SAGD (FA-SAGD) , 2010 .

[5]  R. Kharrat,et al.  The investigation of suitability of different capillary number definitions for flow behavior characterization of surfactant-based chemical flooding in heavy oil reservoirs , 2012 .

[6]  Xiu-Sheng Li,et al.  Mechanistic simulation studies on the steam-foam drive in superviscous oil reservoirs , 2004 .

[7]  A. Kovscek,et al.  A Study of Steam-Assisted Gravity Drainage Performance in the Presence of Noncondensable Gases , 2002 .

[8]  William R. Rossen,et al.  Injectivity errors in simulation of foam EOR , 2013 .

[9]  Wanli Kang,et al.  A Novel Ultra-low Interfacial Tension Foam Flooding Agent to Enhance Heavy Oil Recovery , 2010 .

[10]  Shuzhong Wang,et al.  Studies on Foam Flow in the Porous Media in the Last Decade: A Review , 2012 .

[11]  A. Kovscek,et al.  Foam Mobility in Heterogeneous Porous Media , 2003 .

[12]  Guicai Zhang,et al.  Comparative Effectiveness of Alkaline Flooding and Alkaline–Surfactant Flooding for Improved Heavy-Oil Recovery , 2012 .

[13]  Sam Huang.  Comparative Effectiveness of CO2, Produced Gas, and Flue Gas for Enhanced Heavy Oil Recovery , 1997 .

[14]  Anthony R. Kovscek,et al.  Noncondensable gas steam-assisted gravity drainage , 2004 .

[15]  Clarence A. Miller,et al.  Wettability Alteration and Foam Mobility Control in a Layered, 2D Heterogeneous Sandpack , 2012 .

[16]  William R. Rossen,et al.  Optimal Injection Strategies for Foam IOR , 2004 .

[17]  G. Hirasaki.  The Steam-Foam Process , 1989 .

[18]  S. N. Ashrafizadeh,et al.  Emulsification of heavy crude oil in water for pipeline transportation , 2010 .

[19]  Y. Al-Wahaibi,et al.  The novel use of Deep Eutectic Solvents for enhancing heavy oil recovery , 2015 .

[20]  Songyan Li,et al.  Experimental study and application on profile control using high-temperature foam , 2011 .

[21]  Longxin Mu,et al.  Mechanism of heavy oil recovery by cyclic superheated steam stimulation , 2013 .

[22]  Juliana Y. Leung,et al.  In-situ recovery of heavy-oil from fractured carbonate reservoirs: Optimization of steam-over-solvent injection method , 2015 .

[23]  D. Shen,et al.  Conformance Control of CSS and Steam Drive Process With a Carbamide Surfactant , 2009 .

[24]  P. Zitha,et al.  Experimental and modeling studies on foam in porous media: a review , 2000 .