The straight-line method presented by Papadopulos requires a minimum of three observation wells for determining the transmissivity tensor of a homogeneous and anisotropic aquifer. A simplification of this method was developed for fractured aquifers where the principal directions of the transmissivity tensor are known prior to implementation, such as when fracture patterns on outcropping portions of the aquifer may be used to infer the principal directions. This new method assumes that observation wells are drilled along the two principal directions from the pumped well, thus reducing the required number of observation wells to two. This method was applied for an aquifer test in the fractured Navajo Sandstone of southwestern Utah and yielded minimum and maximum principal transmissivity values of 70 and 1800 m(2)/d, respectively, indicating an anisotropy ratio of approximately 24 to 1.
[1]
C. V. Theis.
The relation between the lowering of the Piezometric surface and the rate and duration of discharge of a well using ground‐water storage
,
1935
.
[2]
S. Papadopulos,et al.
NONSTEADY FLOW TO A WELL IN AN INFINITE ANISOTROPIC AQUIFER
,
2005
.
[3]
S. Lohman,et al.
Ground-Water Hydraulics
,
1972
.
[4]
C. E. Jacob,et al.
A generalized graphical method for evaluating formation constants and summarizing well‐field history
,
1946
.
[5]
Geohydrology and numerical simulation of ground-water flow in the central Virgin River basin of Iron and Washington Countries, Utah
,
2000
.
[6]
S. P. Neuman.
Analysis of Pumping Test Data From Anisotropic Unconfined Aquifers Considering Delayed Gravity Response
,
1975
.
[7]
K. Perkins,et al.
Gas‐Partitioning Tracer Test to Quantify Trapped Gas During Recharge
,
2004,
Ground water.