Finite element analysis of a femoral retrograde intramedullary nail subject to gait loading.

Intramedullary nails are routinely used in the treatment of fractures of the femur. While their effectiveness has been demonstrated clinically, a number of complications, including bone refracture and implant failure, persist. This paper presents novel three-dimensional finite element (FE) models, at four stages of gait, of: (i) a realistic femur analogue known as third generation composite bone, and (ii) a system consisting of an intramedullary nail implanted in the femur of (i). A comparison of experimentally measured strains on the surface of the femur with those predicted by the FE model revealed good agreement. The models were then used to identify implant/bone load sharing patterns, and areas of stress concentration in both the intramedullary nail and the bone, when statically locked by one or two screws at either end. The results of this study can be used to guide future implant design and surgical procedure.

[1]  M. Liebergall,et al.  Femoral fracture at the proximal end of an intramedullary supracondylar nail: a case report. , 1999, American journal of orthopedics.

[2]  J. Wolff.  Das Gesetz der Transformation der Knochen , 1893 .

[3]  E Y Chao,et al.  Internal forces and moments in the femur during walking. , 1997, Journal of biomechanics.

[4]  W. Hayes,et al.  Role of loads and prosthesis material properties on the mechanics of the proximal femur after total hip arthroplasty , 1992, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[5]  H J Sommer,et al.  Three-dimensional osteometric scaling and normative modelling of skeletal segments. , 1982, Journal of biomechanics.

[6]  P. Broos,et al.  Healing of closed femoral shaft fractures treated with the AO unreamed femoral nail. A comparative study with the AO reamed femoral nail. , 2000, Injury.

[7]  T D Brown,et al.  Structural properties of a new design of composite replicate femurs and tibias. , 2001, Journal of biomechanics.

[8]  W C Hayes,et al.  Three-dimensional finite element analysis of a simplified compression plate fixation system. , 1984, Journal of biomechanical engineering.

[9]  K. Koval,et al.  Distal Femoral Nonunion: Treatment with a Retrograde Inserted Locked Intramedullary Nail , 1995, Journal of orthopaedic trauma.

[10]  A L Yettram,et al.  Intramedullary femoral nails: one or two lag screws? A preliminary study. , 2000, Medical engineering & physics.

[11]  W. Hayes,et al.  Stress analysis of compression plate fixation and its effects on long bone remodeling. , 1985, Journal of biomechanics.

[12]  R J Eveleigh,et al.  A review of biomechanical studies of intramedullary nails. , 1995, Medical engineering & physics.

[13]  A. Yettram,et al.  Stress and strain distribution within the intact femur: compression or bending? , 1996, Medical engineering & physics.

[14]  A L Yettram,et al.  Finite element analysis of a Gamma nail within a fractured femur. , 1998, Medical engineering & physics.

[15]  L Cristofolini,et al.  A comparative study on different methods of automatic mesh generation of human femurs. , 1998, Medical engineering & physics.

[16]  W. Hayes,et al.  STRESS ANALYSIS OF A SIMPLIFIED COMPRESSION PLATE FIXATION SYSTEM FOR FRACTURED BONES††This work was supported by NIH RCDA AM00749 and by a research grant from Synthes, Ltd. , 1983 .

[17]  C. Born,et al.  Initial Experience with the Treatment of Supracondylar Femoral Fractures Using the Supracondylar Intramedullary Nail: A Preliminary Report , 1994, Journal of orthopaedic trauma.

[18]  L Cristofolini,et al.  Mechanical validation of whole bone composite femur models. , 1996, Journal of biomechanics.

[19]  A. Cappello,et al.  Mechanical validation of whole bone composite tibia models. , 2000, Journal of biomechanics.

[20]  B. Nigg,et al.  The effect of muscle stiffness and damping on simulated impact force peaks during running. , 1999, Journal of biomechanics.

[21]  Richard A. Brand,et al.  Implantable telemetry in orthopaedics , 1991 .

[22]  E. Schneider,et al.  Influence of muscle forces on femoral strain distribution. , 1998, Journal of biomechanics.

[23]  T. Terjesen,et al.  Femoral shaft fractures treated by intramedullary nailing. A follow-up study focusing on problems related to the method. , 1995, Injury.

[24]  Anthony W. Miles,et al.  An Investigation into the Load Transfer in Interlocking Intramedullary Nails during Simulated Healing of a Femoral Fracture , 1994 .

[25]  L Cristofolini,et al.  The 'standardized femur program' proposal for a reference geometry to be used for the creation of finite element models of the femur. , 1996, Journal of biomechanics.

[26]  J. Albareda,et al.  Biomechanical study of the Grosse-Kempf femoral nail , 1997, International Orthopaedics.

[27]  E Schneider,et al.  Loads acting in an intramedullary nail during fracture healing in the human femur. , 2001, Journal of biomechanics.

[28]  B P McNamara,et al.  Relationship between bone-prosthesis bonding and load transfer in total hip reconstruction. , 1997, Journal of biomechanics.