Interface toughness of carbon nanotube reinforced epoxy composites.

Traditional single-fiber pull-out type experiments were conducted on individual multiwalled carbon nanotubes (MWNT) embedded in an epoxy matrix using a novel technique. Remarkably, the results are qualitatively consistent with the predictions of continuum fracture mechanics models. Unstable interface crack propagation occurred at short MWNT embedments, which essentially exhibited a linear load-displacement response prior to peak load. Deep embedments, however, enabled stable crack extension and produced a nonlinear load-displacement response prior to peak load. The maximum pull-out forces corresponding to a wide range of embedments were used to compute the nominal interfacial shear strength and the interfacial fracture energy of the pristine MWNT-epoxy interface.

[1]  P. Ajayan,et al.  Effect of nitrogen doping on the mechanical properties of carbon nanotubes. , 2010, ACS nano.

[2]  Hao Lu,et al.  Development and Application of a Novel Microfabricated Device for the In Situ Tensile Testing of 1-D Nanomaterials , 2010, Journal of Microelectromechanical Systems.

[3]  Jun Lou,et al.  A Multi-step Method for In Situ Mechanical Characterization of 1-D Nanostructures Using a Novel Micromechanical Device , 2010 .

[4]  K W Wang,et al.  The interfacial strength of carbon nanofiber epoxy composite using single fiber pullout experiments , 2009, Nanotechnology.

[5]  J. Lou,et al.  The mechanical characterization of carbon-nanotube-reinforced polymer-matrix nanocomposites: An unfolding story of interface , 2009 .

[6]  Mark A. Locascio,et al.  Measurements of near-ultimate strength for multiwalled carbon nanotubes and irradiation-induced crosslinking improvements. , 2008, Nature nanotechnology.

[7]  Linda S. Schadler,et al.  Fracture Transitions at a Carbon‐Nanotube/Polymer Interface , 2006 .

[8]  H. Kahn,et al.  Nano measurements with micro-devices: mechanical properties of hydrated collagen fibrils , 2006, Journal of The Royal Society Interface.

[9]  Sidney R. Cohen,et al.  Interfacial fracture energy measurements for multi-walled carbon nanotubes pulled from a polymer matrix , 2004 .

[10]  K. Liao,et al.  Interfacial characteristics of a carbon nanotube–polystyrene composite system , 2001 .

[11]  E. Mäder,et al.  Investigation of load transfer between the fiber and the matrix in pull-out tests with fibers having different diameters , 2001 .

[12]  R. Ruoff,et al.  Strength and breaking mechanism of multiwalled carbon nanotubes under tensile load , 2000, Science.

[13]  Reshef Tenne,et al.  Stress-induced fragmentation of multiwall carbon nanotubes in a polymer matrix , 1998 .

[14]  Charles M. Lieber,et al.  Nanobeam Mechanics: Elasticity, Strength, and Toughness of Nanorods and Nanotubes , 1997 .

[15]  H. Wagner,et al.  Interface toughness in fibre composites by the fragmentation test , 1996 .

[16]  L. Penn,et al.  Improved analysis and experimental evaluation of the single filament pull-out test , 1992 .

[17]  C. Galiotis.  Interfacial studies on model composites by laser Raman spectroscopy , 1991 .

[18]  L. Penn,et al.  Interpretation of Experimental Results in the Single Pull-out Filament Test , 1989 .