Numerical investigation on practicability of reducing MCST by using grid spacer in a tight rod bundle

Abstract The numerical investigation was carried out to reveal the practicability of reducing the maximum cladding surface temperature (MCST) within the inner sub-channel of a tight, hexagon rod bundle using commercial CFD code STAR CCM+ 6.04. The special heat transfer and pressure drop characteristics caused by four existing grid spacer designs were discussed in detail by analyzing the effects of grid strap length, different flow enhancing features and different Reynolds numbers. It was found that the local heat transfer within the grid strap is greatly enhanced due to the raised flow velocity. Both the standard grid spacer and the grid spacer with split-vanes cause decreased heat transfer in the downstream region. The friction drag is very influential in the tight rod bundle and can eliminate the positive effect of flow blockage on the heat transfer performance. The grid spacer with flow blockage discs induces relatively good heat transfer performance and higher pressure drop within sub-channels, indicating a tradeoff between the heat transfer augmentation and the pressure drop. The combination of multiple existing grid spacers can reduce the MCST to a certain level, but the corresponding disadvantages cannot be ignored. The improved grid spacer design was proposed based on the overall considerations of heat transfer and pressure drop characteristics and has been proved more suitable to widely reduce MCST for SCWR than any other grid spacer designs involved in present study.

[1]  H. L. Norris,et al.  Turbulent channel flow with a moving wavy boundary , 1975 .

[2]  Yue Fen Shen,et al.  An investigation of crossflow mixing effect caused by grid spacer with mixing blades in a rod bundle , 1991 .

[3]  D. E. Beasley,et al.  Development of Swirling Flow in a Rod Bundle Subchannel , 2002 .

[4]  H. Anglart,et al.  Experimental investigation of turbulent flow through spacer grids in fuel rod bundles , 2009 .

[5]  Michael E. Conner,et al.  The Effect of Support Grid Features on Local, Single-Phase Heat Transfer Measurements in Rod Bundles , 2004 .

[6]  Yoshiaki Oka,et al.  Numerical investigation of heat transfer in upward flows of supercritical water in circular tubes and tight fuel rod bundles , 2007 .

[7]  F. Dittus,et al.  Heat transfer in automobile radiators of the tubular type , 1930 .

[8]  Moon Ki Chung,et al.  Turbulent flow through spacer grids in rod bundles , 1998 .

[9]  Young Don Choi,et al.  Comparison of thermo-hydraulic performances of large scale vortex flow (LSVF) and small scale vortex flow (SSVF) mixing vanes in 17 × 17 nuclear rod bundle , 2007 .

[10]  M. Watts,et al.  MIXED CONVECTION HEAT TRANSFER TO SUPERCRITICAL PRESSURE WATER , 1982 .

[11]  Xu Cheng,et al.  Numerical analysis of heat transfer in supercritical water cooled flow channels , 2007 .

[12]  Chunkuan Shih,et al.  CFD evaluation of turbulence models for flow simulation of the fuel rod bundle with a spacer assembly , 2012 .

[13]  W. Leech,et al.  Heat-Transfer Augmentation in Rod Bundles Near Grid Spacers , 1982 .

[14]  Kwang-Yong Kim,et al.  Numerical Optimization for the Design of a Spacer Grid with Mixing Vanes in a Pressurized Water Reactor Fuel Assembly , 2005 .

[15]  H. S. Swenson,et al.  Heat Transfer to Supercritical Water in Smooth-Bore Tubes , 1965 .

[16]  M. Wolfshtein.  The velocity and temperature distribution in one-dimensional flow with turbulence augmentation and pressure gradient , 1969 .