Modeling field-scale cosolvent flooding for DNAPL source zone remediation.

A three-dimensional, compositional, multiphase flow simulator was used to model a field-scale test of DNAPL removal by cosolvent flooding. The DNAPL at this site was tetrachloroethylene (PCE), and the flooding solution was an ethanol/water mixture, with up to 95% ethanol. The numerical model, UTCHEM accounts for the equilibrium phase behavior and multiphase flow of a ternary ethanol-PCE-water system. Simulations of enhanced cosolvent flooding using a kinetic interphase mass transfer approach show that when a very high concentration of alcohol is injected, the DNAPL/water/alcohol mixture forms a single phase and local mass transfer limitations become irrelevant. The field simulations were carried out in three steps. At the first level, a simple uncalibrated layered model is developed. This model is capable of roughly reproducing the production well concentrations of alcohol, but not of PCE. A more refined (but uncalibrated) permeability model is able to accurately simulate the breakthrough concentrations of injected alcohol from the production wells, but is unable to accurately predict the PCE removal. The final model uses a calibration of the initial PCE distribution to get good matches with the PCE effluent curves from the extraction wells. It is evident that the effectiveness of DNAPL source zone remediation is mainly affected by characteristics of the spatial heterogeneity of porous media and the variable (and unknown) DNAPL distribution. The inherent uncertainty in the DNAPL distribution at real field sites means that some form of calibration of the initial contaminant distribution will almost always be required to match contaminant effluent breakthrough curves.

[1]  Lakshmi N. Reddi,et al.  Non-aqueous phase liquids (NAPLs) in subsurface environment : assessment and remediation : proceedings of the specialty conference held in conjunction with the ASCE National Convention, Washington, D.C., November 12-14, 1996 , 1996 .

[2]  A. L. Wood,et al.  Field‐scale evaluation of in situ cosolvent flushing for enhanced aquifer remediation , 1997 .

[3]  N. Hayden,et al.  Phase Behavior of Chlorinated Solvent + Water + Alcohol Mixtures with Application to Alcohol Flushing , 1999 .

[4]  Ronald W. Falta,et al.  Modeling unstable alcohol flooding of DNAPL-contaminated columns , 2001 .

[5]  Kamy Sepehrnoori,et al.  Application of higher-order flux-limited methods in compositional simulation , 1994 .

[6]  Buqiang Li,et al.  Interfacial tensions of two-liquid-phase ternary systems , 1992 .

[7]  J. Jawitz,et al.  Miscible fluid displacement stability in unconfined porous media:. Two-dimensional flow experiments and simulations , 1998 .

[8]  R. H. Brooks,et al.  Properties of Porous Media Affecting Fluid Flow , 1966 .

[9]  Van Genuchten,et al.  A closed-form equation for predicting the hydraulic conductivity of unsaturated soils , 1980 .

[10]  Ronald W. Falta,et al.  Using Phase Diagrams to Predict the Performance of Cosolvent Floods for NAPL Remediation , 1998 .

[11]  L. Lake,et al.  Enhanced Oil Recovery , 2017 .

[12]  Chun Huh,et al.  Interfacial tensions and solubilizing ability of a microemulsion phase that coexists with oil and brine , 1979 .

[13]  Kamy Sepehrnoori,et al.  Improvements in Physical-Property Models Used in Micellar/Polymer Flooding , 1987 .

[14]  D. Brandes,et al.  Importance of phase behavior on the removal of residual DNAPLs from porous media by alcohol flooding , 1993 .

[15]  Kamy Sepehrnoori,et al.  Simulation of surfactant-enhanced aquifer remediation , 1994 .

[16]  A. L. Wood,et al.  Controlled release, blind test of DNAPL remediation by ethanol flushing. , 2004, Journal of contaminant hydrology.

[17]  Hailian Liang.  Multiphase Flow Modeling of Field Scale Cosolvent Flooding for DNAPL Remediation , 2005 .

[18]  A. L. Wood,et al.  Field test of high molecular weight alcohol flushing for subsurface nonaqueous phase liquid remediation , 1999 .

[19]  Kamy Sepehrnoori,et al.  A compositional simulator for modeling surfactant enhanced aquifer remediation, 1 Formulation , 1996 .

[20]  T. Sale,et al.  Steady state mass transfer from single‐component dense nonaqueous phase liquids in uniform flow fields , 2001 .

[21]  A. L. Wood,et al.  Field evaluation of the solvent extraction residual biotreatment technology. , 2003, Environmental Science and Technology.

[22]  J. Jawitz,et al.  In-situ alcohol flushing of a DNAPL source zone at a dry cleaner site. , 2000 .

[23]  B. Kueper,et al.  Manipulation of density and viscosity for the optimization of DNAPL recovery by alcohol flooding , 1999 .

[24]  R. Falta,et al.  DNAPL to LNAPL Transitions During Horizontal Cosolvent Flooding , 2001 .

[25]  Michael J. King,et al.  High-resolution monotonic schemes for reservoir fluid flow simulation , 1991 .

[26]  B. Kueper,et al.  Removal of pooled dense, nonaqueous phase liquid from saturated porous media using upward gradient alcohol floods , 1997 .

[27]  B. Kueper,et al.  Risk Reduction during Chemical Flooding: Preconditioning DNAPL Density In Situ Prior to Recovery by Miscible Displacement , 1999 .

[28]  B. Kueper,et al.  Non-equilibrium alcohol flooding model for immiscible phase remediation: 1. Equation development , 1998 .

[29]  R. L. Reed,et al.  Physsicochemical Aspects of Microemulsion Flooding , 1974 .

[30]  Gary A. Pope,et al.  Chemical flooding compositional simulator , 1978 .