A wind-tunnel study of flow distortion at a meteorological sensor on top of the BT Tower, London, UK

High quality wind measurements in cities are needed for numerous applications including wind engineering. Such data-sets are rare and measurement platforms may not be optimal for meteorological observations. Two years' wind data were collected on the BT Tower, London, UK, showing an upward deflection on average for all wind directions. Wind tunnel simulations were performed to investigate flow distortion around two scale models of the Tower. Using a 1:160 scale model it was shown that the Tower causes a small deflection (ca. 0.5°) compared to the lattice on top on which the instruments were placed (ca. 0–4°). These deflections may have been underestimated due to wind tunnel blockage. Using a 1:40 model, the observed flow pattern was consistent with streamwise vortex pairs shed from the upstream lattice edge. Correction factors were derived for different wind directions and reduced deflection in the full-scale data-set by <3°. Instrumental tilt caused a sinusoidal variation in deflection of ca. 2°. The residual deflection (ca. 3°) was attributed to the Tower itself. Correction of the wind-speeds was small (average 1%) therefore it was deduced that flow distortion does not significantly affect the measured wind-speeds and the wind climate statistics are reliable.

[1]  Andreas Christen,et al.  Atmospheric turbulence and surface energy exchange in urban environments : results from the Basel Urban Boundary Layer Experiment (BUBBLE) , 2005 .

[2]  Bengamin I. Moat,et al.  CFD model estimates of the airflow distortion over research ships and the impact on momentum flux measurements , 2002 .

[3]  A. J. Dyer,et al.  Flow distortion by supporting structures , 1981 .

[4]  Matthias Roth,et al.  Review of atmospheric turbulence over cities , 2007 .

[5]  Hans Peter Schmid,et al.  Experimental design for flux measurements: matching scales of observations and fluxes , 1997 .

[6]  Dennis W. Camp,et al.  Comparison of tower influence on wind velocity for NASA's 150-meter meteorological tower and a wind tunnel model of the tower , 1970 .

[7]  John C. Wyngaard,et al.  Comments on ‘Flow distortion by supporting structures’, by A. C. Dyer , 1982 .

[8]  Alison S. Tomlin,et al.  Referencing of street-level flows measured during the DAPPLE 2004 campaign , 2009 .

[9]  Janet F. Barlow,et al.  Turbulent Flow at 190 m Height Above London During 2006–2008: A Climatology and the Applicability of Similarity Theory , 2010 .

[10]  Anthony F. Molland,et al.  Quantifying the Airflow Distortion over Merchant Ships. Part I: Validation of a , 2006 .

[11]  Y. Qian,et al.  Local Similarity Relationships In The Urban Boundary Layer , 2002 .

[12]  Mathias W. Rotach,et al.  On the influence of the urban roughness sublayer on turbulence and dispersion , 1999 .

[13]  Franz Fiedler,et al.  Turbulence Structure in the Wake Region of a Meteorological Tower , 2003 .

[14]  John C. Wyngaard,et al.  The Kansas and Minnesota experiments , 1990 .

[15]  Andres Schmidt,et al.  Advanced tilt correction from flow distortion effects on turbulent CO2 fluxes in complex environments using large eddy simulation , 2009 .

[16]  Anthony F. Molland,et al.  Quantifying the Airflow Distortion over Merchant Ships. Part II: Application of the Model Results , 2006 .

[17]  Janet F. Barlow,et al.  A review of urban roughness sublayer turbulence , 2008 .

[18]  J. Wieringa,et al.  A revaluation of the Kansas mast influence on measurements of stress and cup anemometer overspeeding , 1980 .