Development of tools for DER components in a distribution network

The increasing amount of Distributed Energy Resources (DER) components into distribution networks involves the development of accurate simulation models that take into account an increasing number of factors that influence the output power from the DG systems. This paper presents two simulation models: a PV system model using the single-diode four-parameter model based on data sheet values and a Vanadium Redox Battery (VRB) system model based on the efficiency of different components and the power losses. The unit models were implemented first in MATLAB/Simulink and the simulation results have been compared with the data sheet values and with the characteristics of the units. To point out the strong dependency on ambient conditions and to validate the simulation models a complex data processing subsystem model has also been developed. A PV and a VRB inverter models have also been developed and implemented in PowerFactory to study load flow, steady-state voltage stability and dynamic behavior of a distribution system.

[1]  R. Teodorescu,et al.  Stand-alone wind system with Vanadium Redox Battery energy storage , 2008, 2008 11th International Conference on Optimization of Electrical and Electronic Equipment.

[2]  William A. Beckman,et al.  Improvement and validation of a model for photovoltaic array performance , 2006 .

[3]  Michael Jensen,et al.  Model and simulation of a 75kW PV solar array , 2010, IEEE PES T&D 2010.

[4]  E. Skoplaki,et al.  A simple correlation for the operating temperature of photovoltaic modules of arbitrary mounting , 2008 .

[5]  Xu Rong,et al.  A review on distributed energy resources and MicroGrid , 2008 .

[6]  Henrik W. Bindner,et al.  Characterization of Vanadium Flow Battery , 2010 .

[7]  Pedro Rodriguez,et al.  PV panel model based on datasheet values , 2007, 2007 IEEE International Symposium on Industrial Electronics.

[8]  L. Mihet-Popa,et al.  Development of tools for simulation systems in a distribution network and validated by measurements , 2012, 2012 13th International Conference on Optimization of Electrical and Electronic Equipment (OPTIM).

[9]  Y Riffonneau,et al.  Optimal Power Flow Management for Grid Connected PV Systems With Batteries , 2011, IEEE Transactions on Sustainable Energy.

[10]  R. Miceli,et al.  Flexible power converters for the fault tolerant operation of Micro-Grids , 2010, The XIX International Conference on Electrical Machines - ICEM 2010.

[11]  Baoming Ge,et al.  Grid-connected wind farm power control using VRB-based energy storage system , 2010, 2010 IEEE Energy Conversion Congress and Exposition.

[12]  M. Kacira,et al.  Determining optimum tilt angles and orientations of photovoltaic panels in Sanliurfa, Turkey , 2004 .

[13]  Poul Ejnar Sørensen,et al.  Models for a stand-alone PV system , 2001 .

[14]  David Le,et al.  Impact of high penetration of solar photovoltaic generation on power system small signal stability , 2010, 2010 International Conference on Power System Technology.

[15]  Marcelo Gradella Villalva,et al.  Comprehensive Approach to Modeling and Simulation of Photovoltaic Arrays , 2009, IEEE Transactions on Power Electronics.

[16]  G. Štumberger,et al.  Maximum Efficiency Trajectories of a Two-Axis Sun Tracking System Determined Considering Tracking System Consumption , 2011, IEEE Transactions on Power Electronics.