Origin of the response of nanomechanical resonators to bacteria adsorption

Resonant microcantilevers are being actively investigated as sensitive mass sensors for biological detection. By performing experiments of adsorption of the bacteria Escherichia coli on singly clamped microcantilevers, we demonstrate that the effect of the added mass is not the only and may not be the main origin of the response of these sensors. The experiments show that the magnitude and sign of resonance frequency shift both depend critically on the distribution of the adsorbed bacterial cells on the cantilever. We relate this behavior to the added mass that shifts the resonance to lower frequencies and the higher effective flexural rigidity of the cantilever due to the bacteria stiffness that shifts the resonance to higher frequencies. Both effects can be uncoupled by positioning the cells where each effect dominates, near the free cantilever end for measuring the added mass or near the clamping for measuring the increase of flexural rigidity.

[1]  H. Craighead,et al.  Enumeration of DNA molecules bound to a nanomechanical oscillator. , 2005, Nano letters.

[2]  Thomas P. Burg,et al.  Suspended microchannel resonators for biomolecular detection , 2003 .

[3]  Jonathan S. Colton,et al.  Influence of surface stress on the resonance behavior of microcantilevers , 2005 .

[4]  M. Miles,et al.  Chemical sensors and biosensors in liquid environment based on microcantilevers with amplified quality factor. , 2001, Ultramicroscopy.

[5]  M. Roukes,et al.  Ultrasensitive nanoelectromechanical mass detection , 2004, cond-mat/0402528.

[6]  Thomas Thundat,et al.  Adsorption-induced surface stress and its effects on resonance frequency of microcantilevers , 1995 .

[7]  H. Craighead,et al.  Mechanical resonant immunospecific biological detector , 2000 .

[8]  Brian H. Houston,et al.  Effect of viscous loss on mechanical resonators designed for mass detection , 2006 .

[9]  Masayoshi Esashi,et al.  Stress-induced mass detection with a micromechanical/nanomechanical silicon resonator , 2005 .

[10]  Wan Y. Shih,et al.  Effect of length, width, and mode on the mass detection sensitivity of piezoelectric unimorph cantilevers , 2002 .

[11]  Amit K. Gupta,et al.  Single virus particle mass detection using microresonators with nanoscale thickness , 2004 .

[12]  Heow Pueh Lee,et al.  Surface stress effects on the resonance properties of cantilever sensors , 2005 .

[13]  Arvind Raman,et al.  Enhanced mass sensing using torsional and lateral resonances in microcantilevers , 2004 .

[14]  N. G. Stephen,et al.  Beam vibration under compressive axial load—upper and lower bound approximation , 1989 .

[15]  Anja Boisen,et al.  Enhanced functionality of cantilever based mass sensors using higher modes , 2005 .

[16]  F. Frost,et al.  Highly ordered self-organized dot patterns on Si surfaces by low-energy ion-beam erosion , 2005 .

[17]  Martin Hegner,et al.  Micromechanical oscillators as rapid biosensor for the detection of active growth of Escherichia coli. , 2005, Biosensors & bioelectronics.

[18]  Martin Hegner,et al.  Rapid functionalization of cantilever array sensors by inkjet printing , 2004 .

[19]  D. Pink,et al.  Thickness and Elasticity of Gram-Negative Murein Sacculi Measured by Atomic Force Microscopy , 1999, Journal of bacteriology.

[20]  Tae Song Kim,et al.  Effect of mass and stress on resonant frequency shift of functionalized Pb(Zr0.52Ti0.48)O3 thin film microcantilever for the detection of C-reactive protein , 2004 .

[21]  M. Sepaniak,et al.  Cantilever transducers as a platform for chemical and biological sensors , 2004 .