A Benchmark Study of Finite Element Codes for Forming Simulation of Thermoplastic UD-Tapes ☆

Abstract For Finite Element (FE) simulation of composite thermoforming processes, either commercially available codes or multi-purpose FE solvers can be applied. In this work, the commercially available codes AniForm and PAM-FORM, as well as two approaches implemented in the multi-purpose FE solvers LS-Dyna and Abaqus are benchmarked in a comparative study. For this purpose, the final outer contour, as well as wrinkling behavior is analyzed in experimental forming studies and compared to the virtual predictions. It turns out, that FE forming simulation is capable to predict manufacturing defects. However, the capabilities and quality of the prediction of the considered tools differ.

[1]  F. Field,et al.  Strategic Materials Selection In The Automobile Body: Economic Opportunities for Polymer Composite Design , 2008 .

[2]  Emmanuelle Vidal-Salle,et al.  Simulation of wrinkling during textile composite reinforcement forming. Influence of tensile, in-plane shear and bending stiffnesses , 2011 .

[3]  Jan-Anders E. Månson,et al.  Manufacturing cost comparison of thermoplastic and thermoset RTM for an automative floor-plan , 2004 .

[4]  Frank Henning,et al.  A method for validation of finite element forming simulation on basis of a pointwise comparison of distance and curvature , 2016 .

[5]  R. Akkerman,et al.  Bending Characterization of UD Composites , 2014 .

[6]  Ignace Verpoest,et al.  Experimental validation of forming simulations of fabric reinforced polymers using an unsymmetrical mould configuration , 2009 .

[7]  P. Boisse,et al.  Thermomechanical analysis, modelling and simulation of the forming of pre-impregnated thermoplastics composites , 2015 .

[8]  T. Osswald,et al.  A thermo-viscoelastic approach for the characterization and modeling of the bending behavior of thermoplastic composites – Part II , 2016 .

[9]  Frank Henning,et al.  A viscoelastic approach for modeling bending behavior in finite element forming simulation of continuously fiber reinforced composites , 2017 .

[10]  R. Akkerman,et al.  Shear characterisation of uni-directional fibre reinforced thermoplastic melts by means of torsion , 2014 .

[11]  Remko Akkerman,et al.  Formability analyses of uni-directional and textile reinforced thermoplastics , 2014 .

[12]  P. Boisse,et al.  Simulation of thermoplastic prepreg thermoforming based on a visco-hyperelastic model and a thermal homogenization , 2016 .

[13]  Anthony K. Pickett,et al.  Numerical and experimental investigation of some press forming parameters of two fibre reinforced thermoplastics: APC2-AS4 and PEI-CETEX , 1998 .