Helicopter interior noise reduction using compounded periodic struts

Abstract This paper characterizes the performance of a novel compounded gearbox periodic strut on controlling the noise in a helicopter cabin through modelling, simulation and experimental research. The strut exhibits low transmissibility in the specified frequency ranges, called “stop bands”. Based on a certain helicopter model, a dynamic acoustic-structure coupled system is first built by using the finite element method and the transfer matrix method. Subsequently, according to the gear mesh vibration transmission path, analyses of the vibration and noise reduction characteristics are conducted. Compared with the plain strut, attenuations of both vibration and noise in excess of 60 dB are obtained in the simulations. On a specially designed helicopter platform, experimental research is conducted simultaneously on the two aspects of fuselage vibration and cabin noise. The effectiveness of the novel strut used for helicopter cabin broadband noise reduction is demonstrated by the agreement between the simulation and experimentation results, where the attenuations of measured fuselage vibration and cabin noise exceed the levels of 40 dB and 30 dB, respectively, in the frequency range from 300 to 2000 Hz.

[1]  George A. Lesieutre,et al.  Multi-layered Radial Isolator for Helicopter Interior Noise Reduction , 2013 .

[2]  Michael J. Brennan,et al.  Mechanisms of noise transmission through helicopter gearbox support struts , 1994 .

[3]  Wim Desmet,et al.  Active noise control in agricultural machines , 2002 .

[4]  Edward C. Smith,et al.  DESIGN AND TESTING OF A COMPACT LAYERED ISOLATOR FOR HIGH- FREQUENCY HELICOPTER GEARBOX ISOLATION , 2004 .

[5]  T. J. Sutton,et al.  ACTIVE ISOLATION OF MULTIPLE STRUCTURAL WAVES ON A HELICOPTER GEARBOX SUPPORT STRUT , 1997 .

[6]  G. Mathur,et al.  Analytical and Experimental Evaluation of Active Structural Acoustic Control (ASAC) of Helicopter Cabin Noise , 2002 .

[7]  Edward C. Smith,et al.  Analysis and design of high frequency periodically layered isolators in compression , 2000 .

[8]  Mark W. Davis,et al.  Flight Test of Active Gear-Mesh Noise Control on the S-76 Aircraft , 1998 .

[9]  Darryll J. Pines,et al.  Periodic Struts for Gearbox Support System , 2005 .

[10]  Edward C. Smith,et al.  FORMULATION AND VALIDATION OF A RITZ-BASED ANALYTICAL MODEL FOR DESIGN OF PERIODICALLY-LAYERED ISOLATORS IN COMPRESSION , 2001 .

[11]  Darryll J. Pines,et al.  Passive Reduction of Gear Mesh Vibration Using a Periodic Drive Shaft , 2001 .

[12]  Rudolf Maier,et al.  Helicopter Interior Noise Reduction by Using Active Gearbox Struts , 2006 .

[13]  Joseph T. Szefi,et al.  HELICOPTER GEARBOX ISOLATION USING PERIODICALLY LAYERED FLUIDIC ISOLATORS , 2003 .

[14]  Jan Swevers,et al.  Active structural acoustic control of rotating machinery using piezo-based rotating inertial actuators , 2014 .

[15]  Rudolf Maier,et al.  Active Vibration Isolation System for Helicopter Interior Noise Reduction , 2002 .

[16]  Yang Lu,et al.  Active control of multifrequency helicopter vibrations using discrete model predictive sliding mode control , 2016 .

[17]  Edward C. Smith,et al.  Design and Analysis of High-Frequency Periodically Layered Isolators for Helicopter Gearbox Isolation , 2003 .