Transient Thermometry and High-Resolution Transmission Electron Microscopy Analysis of Filamentary Resistive Switches.

We present data on the filament size and temperature distribution in Hf0.82Al0.18Ox-based Resistive Random Access Memory (RRAM) devices obtained by transient thermometry and high-resolution transmission electron microscopy (HRTEM). The thermometry shows that the temperature of the nonvolatile conducting filament can reach temperatures as high as 1600 K at the onset of RESET at voltage of 0.8 V and power of 40 μW. The size of the filament was estimated at about 1 nm in diameter. Hot filament increases the temperature of the surrounding high resistivity oxide, causing it to conduct and carry a significant fraction of the total current. The current spreading results in slowing down the filament temperature increase at higher power. The results of thermometry have been corroborated by HRTEM analysis of the as-fabricated and switched RRAM devices. The functional HfAlOx layer in as-fabricated devices is amorphous. In devices that were switched, we detected a small crystalline region of 10-15 nm in size. The crystallization temperature of the HfAlOx was determined to be 850 K in an independent annealing experiment. The size of the crystalline region agrees with thermal modeling based on the thermometry data. Scanning transmission electron microscopy (TEM) coordinated with electron energy loss spectroscopy could not detect changes in the chemical makeup of the filament.

[1]  J. Yang,et al.  Direct Identification of the Conducting Channels in a Functioning Memristive Device , 2010, Advanced materials.

[2]  P. Raad,et al.  Thermal transport properties of gold-covered thin-film silicon dioxide , 2002, ITherm 2002. Eighth Intersociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems (Cat. No.02CH37258).

[3]  Jang‐Sik Lee,et al.  Reproducible resistance switching characteristics of hafnium oxide-based nonvolatile memory devices , 2008 .

[4]  C. Y. Chen,et al.  Understanding the impact of programming pulses and electrode materials on the endurance properties of scaled Ta2O5 RRAM cells , 2014, 2014 IEEE International Electron Devices Meeting.

[5]  Rainer Waser,et al.  TiO2—a prototypical memristive material , 2011, Nanotechnology.

[6]  Matthew D. Pickett,et al.  The mechanism of electroforming of metal oxide memristive switches , 2009, Nanotechnology.

[7]  Shinhyun Choi,et al.  Comprehensive physical model of dynamic resistive switching in an oxide memristor. , 2014, ACS nano.

[8]  J. Bain,et al.  Electronic Instabilities Leading to Electroformation of Binary Metal Oxide‐based Resistive Switches , 2014 .

[9]  R. Egerton.  Electron energy-loss spectroscopy in the TEM , 2008 .

[10]  Shimeng Yu,et al.  Improved Uniformity of Resistive Switching Behaviors in HfO2 Thin Films with Embedded Al Layers , 2010 .

[11]  R. Degraeve,et al.  Reliability of low current filamentary HfO2 RRAM discussed in the framework of the hourglass SET/RESET model , 2012, 2012 IEEE International Integrated Reliability Workshop Final Report.

[12]  D. Strukov,et al.  Thermophoresis/diffusion as a plausible mechanism for unipolar resistive switching in metal–oxide–metal memristors , 2012, Applied Physics A.

[13]  Jae Hyuck Jang,et al.  Atomic structure of conducting nanofilaments in TiO2 resistive switching memory. , 2010, Nature nanotechnology.

[14]  W. Jang,et al.  Improved Resistive Switching Characteristics by Al2O3 Layers Inclusion in HfO2-Based RRAM Devices , 2013 .

[15]  John Paul Strachan,et al.  The switching location of a bipolar memristor: chemical, thermal and structural mapping , 2011, Nanotechnology.

[16]  L. Goux,et al.  Stochastic variability of vacancy filament configuration in ultra-thin dielectric RRAM and its impact on OFF-state reliability , 2013, 2013 IEEE International Electron Devices Meeting.

[17]  James A. Strickland.  Time-domain reflectometry measurements , 1970 .

[18]  S. Balatti,et al.  Resistive Switching by Voltage-Driven Ion Migration in Bipolar RRAM—Part II: Modeling , 2012, IEEE Transactions on Electron Devices.

[19]  Frederick T. Chen,et al.  Low power and high speed bipolar switching with a thin reactive Ti buffer layer in robust HfO2 based RRAM , 2008, 2008 IEEE International Electron Devices Meeting.

[20]  Shimeng Yu,et al.  Metal–Oxide RRAM , 2012, Proceedings of the IEEE.

[21]  Gang Chen.  Nanoscale energy transport and conversion : a parallel treatment of electrons, molecules, phonons, and photons , 2005 .

[22]  Eilam Yalon,et al.  Thermometry of Filamentary RRAM Devices , 2015, IEEE Transactions on Electron Devices.

[23]  Shimeng Yu,et al.  A Phenomenological Model for the Reset Mechanism of Metal Oxide RRAM , 2010, IEEE Electron Device Letters.

[24]  Stefan Schulz,et al.  Thermal conductivity of ultra low- k dielectrics , 2003 .

[25]  R. Degraeve,et al.  Quantitative endurance failure model for filamentary RRAM , 2015, 2015 Symposium on VLSI Technology (VLSI Technology).

[26]  O. Richard,et al.  Imaging the Three-Dimensional Conductive Channel in Filamentary-Based Oxide Resistive Switching Memory. , 2015, Nano letters.

[27]  J. Yang,et al.  Electrical transport and thermometry of electroformed titanium dioxide memristive switches , 2009 .

[28]  L. Goux,et al.  Understanding of the endurance failure in scaled HfO2-based 1T1R RRAM through vacancy mobility degradation , 2012, 2012 International Electron Devices Meeting.

[29]  James A. Bain,et al.  Oxygen Vacancy Creation, Drift, and Aggregation in TiO2‐Based Resistive Switches at Low Temperature and Voltage , 2015 .

[30]  Malgorzata Jurczak,et al.  Complementary Role of Field and Temperature in Triggering ON/OFF Switching Mechanisms in ${\rm Hf}/{\rm HfO}_{2}$ Resistive RAM Cells , 2013, IEEE Transactions on Electron Devices.

[31]  R. Waser,et al.  Characteristic electroforming behavior in Pt/TiO2/Pt resistive switching cells depending on atmosphere , 2008 .