A 150mV-1.2V fully-integrated DC-DC converter for Thermal Energy Harvesting

A fully-integrated DC/DC converter for energy harvesting applications is presented. The startup-voltage of the converter is about 140mV, the output voltage exceeds 1.5V, with a power efficiency at least 20%. The architecture for boosting such extremely low voltages is based on an ultra-low-voltage oscillator cross connected to two phase charge pump. The overall circuit does not require any external components and can be fully integrated in a standard CMOS low voltage technology. A test-chip has been designed in UMC 0.18μm process.

[1]  G. Iannaccone,et al.  A Sub-1 V, 10 ppm/°C, Nanopower Voltage Reference Generator , 2006, 2006 Proceedings of the 32nd European Solid-State Circuits Conference.

[2]  L. Colalongo,et al.  A 0.2V–1.2V converter for power harvesting applications , 2008, ESSCIRC 2008 - 34th European Solid-State Circuits Conference.

[3]  Anantha Chandrakasan,et al.  A Battery-Less Thermoelectric Energy Harvesting Interface Circuit With 35 mV Startup Voltage , 2010, IEEE Journal of Solid-State Circuits.

[4]  Anantha Chandrakasan,et al.  A batteryless thermoelectric energy-harvesting interface circuit with 35mV startup voltage , 2010, 2010 IEEE International Solid-State Circuits Conference - (ISSCC).

[5]  Leila Parsa,et al.  Maximum energy harvesting from vibration-based electromagnetic microgenerator using active damping , 2010 .

[6]  Chris Van Hoof,et al.  Integrated capacitive power-management circuit for thermal harvesters with output power 10 to 1000µW , 2009, 2009 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[7]  L. Colalongo,et al.  A new lumped model for on-chip inductors including substrate currents , 2003, Proceedings of the 12th IEEE International Conference on Fuzzy Systems (Cat. No.03CH37442).

[8]  H.C. Luong,et al.  Ultra-low-Voltage high-performance CMOS VCOs using transformer feedback , 2005, IEEE Journal of Solid-State Circuits.

[9]  Eric M. Yeatman,et al.  Flexible substrate electrostatic energy harvester , 2010 .

[10]  Giuseppe de Vita,et al.  A Sub-1-V, 10 ppm/ $^{\circ}$C, Nanopower Voltage Reference Generator , 2007, IEEE Journal of Solid-State Circuits.

[11]  Kai Strunz,et al.  A 20 mV Input Boost Converter With Efficient Digital Control for Thermoelectric Energy Harvesting , 2010, IEEE Journal of Solid-State Circuits.

[12]  K. Strunz,et al.  20mV input boost converter for thermoelectric energy harvesting , 2009, 2009 Symposium on VLSI Circuits.

[13]  Bernard H. Stark,et al.  Start-up circuit with low minimum operating power for microwatt energy harvesters , 2011, IET Circuits Devices Syst..

[14]  Alessandro Chini,et al.  Boost-converter-based solar harvester for low power applications , 2010 .

[15]  L. Colalongo,et al.  A 0.2$-\hbox{1.2}$ V DC/DC Boost Converter for Power Harvesting Applications , 2009, IEEE Transactions on Power Electronics.

[16]  M. Pasotti,et al.  Power efficient charge pump in deep submicron standard CMOS technology , 2003, Proceedings of the 27th European Solid-State Circuits Conference.

[17]  Luigi Rovati,et al.  Micro-power photovoltaic harvester based on a frequency-to-voltage MPPT tracker , 2010 .