Flying robots with flapping wings are preferred over conventionally fixed or rotational wings in terms of hovering capability for a simple mechanical configuration. Until recently, available actuators for such a robot are limited to (1) a conventional motor with four-bar linkage mechanism or (2) a piezo electric actuator, but none of them could provide enough lift because of low flapping frequency, small stroke angles, and/or frequent mechanical failure. A new actuator capable of generating large stroke angles with high frequency is developed. It consists of an out-runner brushless motor with a modified motor driver attached to a torsion spring. The wing is attached directly on the cap of the motor. A prototype is built and preliminary thrust force measurements are performed. Properties of wing materials suitable for powerful and robust actuators will be discussed. The actuator employed in the present study utilizes resonance oscillation, which leads to high energy efficiency. Further study of wing shape and directional stiffness is needed for generating higher lift capability.
[1]
C. Ellington,et al.
The mechanics of flight in the hawkmoth Manduca sexta. I. Kinematics of hovering and forward flight.
,
1997,
The Journal of experimental biology.
[2]
Robert J. Wood,et al.
Microrobotics using composite materials: the micromechanical flying insect thorax
,
2003,
2003 IEEE International Conference on Robotics and Automation (Cat. No.03CH37422).
[3]
M. Dickinson,et al.
Wing rotation and the aerodynamic basis of insect flight.
,
1999,
Science.
[4]
J. Gordon Leishman,et al.
Experimental Studies on Insect-Based Flapping Wings for Micro Hovering Air Vehicles
,
2005
.
[5]
T. Daniel,et al.
Into thin air: contributions of aerodynamic and inertial-elastic forces to wing bending in the hawkmoth Manduca sexta
,
2003,
Journal of Experimental Biology.
[6]
C. Ellington.
Unsteady aerodynamics of insect flight.
,
1995,
Symposia of the Society for Experimental Biology.