Structure, Morphology, and Photoelectric Performances of Te-Sb2Se3 Thin Film Prepared via Magnetron Sputtering

Antimony selenide (Sb2Se3) has been widely investigated as a promising absorber material for photovoltaic devices. However, low open-circuit voltage (Voc) limits the power conversion efficiency (PCE) of Sb2Se3-based cells, largely due to the low-charge carrier density. Herein, high-quality n-type (Tellurium) Te-doped Sb2Se3 thin films were successfully prepared using a homemade target via magnetron sputtering. The Te atoms were expected to be inserted in the spacing of (Sb4Se6)n ribbons based on increased lattice parameters in this study. Moreover, the thin film was found to possess a narrow and direct band gap of approximately 1.27 eV, appropriate for harvesting the solar energy. It was found that the photoelectric performance is related to not only the quality of films but also the preferred growth orientation. The Te-Sb2Se3 film annealed at 325 °C showed a maximum photocurrent density of 1.91 mA/cm2 with a light intensity of 10.5 mW/cm2 at a bias of 1.4 V. The fast response and recovery speed confirms the great potential of these films as excellent photodetectors.

[1]  L. Luo,et al.  Initial investigation of B4C–TiB2 composites as neutron absorption material for nuclear reactors , 2020, Journal of Nuclear Materials.

[2]  Hong-li Ma,et al.  Synthesis, structure and photoelectric properties of selenide composites with in situ constructed Sb2Se3/NaSbSe2 heterojunction , 2020, Journal of the European Ceramic Society.

[3]  Hong-li Ma,et al.  An effective combination reaction involved with sputtered and selenized Sb precursors for efficient Sb2Se3 thin film solar cells , 2020, Chemical Engineering Journal.

[4]  Z. Zheng,et al.  In situ synthesis and improved photoelectric performances of a Sb2Se3/β-In2Se3 heterojunction composite with potential photocatalytic activity for methyl orange degradation , 2020 .

[5]  Hong-li Ma,et al.  Sputtered and selenized Sb2Se3 thin-film solar cells with open-circuit voltage exceeding 500 mV , 2020 .

[6]  Ping Luo,et al.  Spark plasma sintering of Sb2Se3 sputtering target towards highly efficient thin film solar cells , 2020 .

[7]  Xianghua Zhang,et al.  Fabrication of Sb2S3 thin films by magnetron sputtering and post-sulfurization/selenization for substrate structured solar cells , 2020 .

[8]  Hong-li Ma,et al.  Fundamental Physical Characterization of Sb2Se3-Based Quasi-Homojunction Thin Film Solar Cells. , 2020, ACS applied materials & interfaces.

[9]  Tao Chen,et al.  Efficient defect passivation of Sb2Se3 film by tellurium doping for high performance solar cells , 2020 .

[10]  Xianghua Zhang,et al.  Controlled Sputtering Pressure on High-Quality Sb2Se3 Thin Film for Substrate Configurated Solar Cells , 2020, Nanomaterials.

[11]  Hong-li Ma,et al.  Magnetron sputtered Sb2Se3-based thin films towards high performance quasi-homojunction thin film solar cells , 2019 .

[12]  X. Jia,et al.  Fabrication of Sb2Se3 thin film solar cells by co-sputtering of Sb2Se3 and Se targets , 2019, Solar Energy.

[13]  Y. Fu,et al.  Highly efficient and stable planar heterojunction solar cell based on sputtered and post-selenized Sb2Se3 thin film , 2019, Nano Energy.

[14]  Jiang Tang,et al.  Orientation Engineering in Low‐Dimensional Crystal‐Structural Materials via Seed Screening , 2019, Advanced materials.

[15]  Jiang Tang,et al.  Solution-processed SnO2 interfacial layer for highly efficient Sb2Se3 thin film solar cells , 2019, Nano Energy.

[16]  G. Fang,et al.  Review of Recent Progress in Antimony Chalcogenide‐Based Solar Cells: Materials and Devices , 2019, Solar RRL.

[17]  Jiang Tang,et al.  Complicated and Unconventional Defect Properties of the Quasi-One-Dimensional Photovoltaic Semiconductor Sb2Se3. , 2019, ACS applied materials & interfaces.

[18]  Yuan Tian,et al.  Facile spray drying approach to synthesize Sb2Se3/rGO composite anode for lithium-ion battery , 2019, Journal of Nanoparticle Research.

[19]  R. Schropp,et al.  9.2%-efficient core-shell structured antimony selenide nanorod array solar cells , 2019, Nature Communications.

[20]  S. Du,et al.  Synthesis and properties of conductive B4C ceramic composites with TiB2 grain network , 2018 .

[21]  T. Chen,et al.  V2O5 as Hole Transporting Material for Efficient All Inorganic Sb2S3 Solar Cells. , 2018, ACS applied materials & interfaces.

[22]  Hong-li Ma,et al.  Enhanced electrical conductivity and photoconductive properties of Sn-doped Sb2Se3 crystals , 2018 .

[23]  Hong-li Ma,et al.  Thermally induced structural evolution and performance of Sb2Se3 films and nanorods prepared by an easy sputtering method , 2018 .

[24]  S. Du,et al.  Densification and mechanical properties of pulsed electric current sintered B4C with in situ synthesized Al3BC obtained by the molten-salt method , 2017 .

[25]  Jiang Tang,et al.  Buried homojunction in CdS/Sb2Se3 thin film photovoltaics generated by interfacial diffusion , 2017 .

[26]  G. Wang,et al.  Enhanced Sb2Se3 solar cell performance through theory‐guided defect control , 2017 .

[27]  Akolade Idris Bakare,et al.  Enhancement of Thermoelectric Behavior of La0.5Co4Sb12−xTex Skutterudite Materials , 2017, Metallurgical and Materials Transactions A.

[28]  Liang Gao,et al.  Characterization of basic physical properties of Sb2Se3 and its relevance for photovoltaics , 2017 .

[29]  Weifeng Liu,et al.  Rapid thermal process to fabricate Sb2Se3 thin film for solar cell application , 2016 .

[30]  Jiang Tang,et al.  The effect of sodium on antimony selenide thin film solar cells , 2016 .

[31]  Bo Yang,et al.  Optical properties of amorphous and polycrystalline Sb2Se3 thin films prepared by thermal evaporation , 2015 .

[32]  Jiang Tang,et al.  Thin-film Sb2Se3 photovoltaics with oriented one-dimensional ribbons and benign grain boundaries , 2015, Nature Photonics.

[33]  Jiang Tang,et al.  Thermal evaporation and characterization of Sb2Se3 thin film for substrate Sb2Se3/CdS solar cells. , 2014, ACS applied materials & interfaces.

[34]  Jiang Tang,et al.  Solution‐Processed Antimony Selenide Heterojunction Solar Cells , 2014 .

[35]  Gebo Pan,et al.  Facile microwave-assisted synthesis of uniform Sb2Se3 nanowires for high performance photodetectors , 2014 .

[36]  T. Nakada,et al.  Cu(In,Ga)Se2 thin film solar cells with a combined ALD-Zn(O,S) buffer and MOCVD-ZnO:B window layers , 2013 .

[37]  G. J. Snyder,et al.  Optical band gap and the Burstein–Moss effect in iodine doped PbTe using diffuse reflectance infrared Fourier transform spectroscopy , 2013 .

[38]  Tianyou Zhai,et al.  Single‐Crystalline Sb2Se3 Nanowires for High‐Performance Field Emitters and Photodetectors , 2010, Advanced materials.

[39]  A. Walsh,et al.  Origins of band-gap renormalization in degenerately doped semiconductors , 2008 .