Assessing the effect of hydrocarbon oil type and thickness on a remote sensing signal: A sensitivity study based on the optical properties of two different oil types and the HYMAP and Quickbird sensors

Abstract We measured the light absorption properties of two naturally occurring Australian hydrocarbon oils, a Gippsland light crude oil and a North West Shelf light condensate. Using the results from these measurements in conjunction with estimated sensor environmental noise thresholds, the theoretical minimum limit of detectability of each oil type (as a function of oil thickness) was calculated for both the hyperspectral HYMAP and multispectral Quickbird sensors. The Gippsland crude oil is discernable at layer thickness of 20 µm or more in the Quickbird green channel. The HYMAP sensor was found to be theoretically capable of detecting a layer of Gippsland crude oil with a thickness of 10 µm in approximately six sensor channels. By contrast, the North West Shelf light condensate was not able to be detected by either sensor for any thickness up to 200 µm. Optical remote sensing is therefore not applicable for detecting diagnostic absorption features associated with this light condensate oil type, which is typical of the chemistry of many hydrocarbon oils found in the Australian Northwest Shelf area and condensates world wide. We conclude that oil type is critical to the applicability of optical remote sensing for natural oil slick detection and identification. We recommend that a sensor- and oil-specific sensitivity study should be conducted prior to applying optical remote sensors for oil exploration. The oil optical properties were obtained using two different laboratory methods, a reflectance-based approach and transmittance-based approach. The reflectance-based approach was relatively complex to implement, but was chosen in order to replicate as closely as possible real world remote sensing measurement conditions of an oil film on water. The transmittance-based approach, based upon standard laboratory spectrophotometric measurements was found to generate results in good agreement with the reflectance-based approach. Therefore, for future oil- and sensor-specific sensitivity studies, we recommend the relatively accessible transmittance-based approach, which is detailed in this paper.