Selective fast pyrolysis of biomass impregnated with ZnCl2 to produce furfural: Analytical Py-GC/MS study

A new technique was proposed to produce furfural (FF) through low-temperature fast pyrolysis of biomass impregnated with ZnCl2. Analytical pyrolysis-gas chromatography/mass spectrometry (Py-GC/MS) experiments were performed in this study to reveal the ZnCl2-catalyzed biomass pyrolysis and FF formation characteristics. The results revealed that the presence of ZnCl2 decreased the temperature for the complete decomposition of biomass, inhibited the devolatilization of lignin and pyrolytic ring scission of holocellulose. Meanwhile, it promoted the depolymerization and dehydration of holocellulose to form the FF and three anhydrosugars (levoglucosenone (LGO), 1-hydroxy-3,6-dioxabicyclo[3.2.1]octan-2-one (LAC) and 1,4:3,6-dianhydro-α-d-glucopyranose (DGP)) as the major primary pyrolytic products. With the increase of the ZnCl2 content, the three anhydrosugars were firstly increased and then decreased, while the FF was increased steadily. Moreover, these anhydrosugars could be converted to FF through the secondary catalysis by ZnCl2, leaving the FF as the predominant product. In addition, the acetic acid (AA), which was not inhibited by the ZnCl2, was formed as the only important liquid by-product.

[1]  J. Encinar,et al.  Catalyzed pyrolysis of grape and olive bagasse. Influence of catalyst type and chemical treatment , 1997 .

[2]  A. Bridgwater,et al.  Lignin fast pyrolysis: results from an international collaboration. , 2010 .

[3]  Sai Gu,et al.  Study on the pyrolytic behaviour of xylan-based hemicellulose using TG–FTIR and Py–GC–FTIR , 2010 .

[4]  Wenzhi Li,et al.  On-line catalytic upgrading of biomass fast pyrolysis products , 2009 .

[5]  C. Blasi,et al.  Pyrolysis of Corncobs Catalyzed by Zinc Chloride for Furfural Production , 2010 .

[6]  Bo Zhang,et al.  Microwave-assisted pyrolysis of biomass: Catalysts to improve product selectivity , 2009 .

[7]  E. Jakab,et al.  Thermal decomposition of milled wood lignins studied by thermogravimetry/mass spectrometry , 1997 .

[8]  S. Saka,et al.  Different action of alkali/alkaline earth metal chlorides on cellulose pyrolysis , 2008 .

[9]  Akwasi A. Boateng,et al.  Chemical Composition of Bio-oils Produced by Fast Pyrolysis of Two Energy Crops † , 2008 .

[10]  A. Bridgwater,et al.  Fast pyrolysis processes for biomass , 2000 .

[11]  C. Blasi,et al.  Products and Global Weight Loss Rates of Wood Decomposition Catalyzed by Zinc Chloride , 2008 .

[12]  G. N. Richards,et al.  Thermal synthesis and pyrolysis of a xylan , 1991 .

[13]  Johan E. Hustad,et al.  Pyrolysis of biomass in the presence of Al-MCM-41 type catalysts , 2005 .

[14]  F. Shafizadeh,et al.  Thermal degradation of 1,6-anhydro-.beta.-D-glucopyranose , 1972 .

[15]  C. Blasi,et al.  Biomass Screening for the Production of Furfural via Thermal Decomposition , 2010 .

[16]  A. Amarasekara,et al.  Zinc chloride mediated degradation of cellulose at 200 degrees C and identification of the products. , 2009, Bioresource technology.

[17]  D. Mohan,et al.  Pyrolysis of Wood/Biomass for Bio-oil: A Critical Review , 2006 .

[18]  S. Gu,et al.  The pyrolytic degradation of wood-derived lignin from pulping process. , 2010, Bioresource technology.

[19]  Z. Tan,et al.  Catalytic effects of eight inorganic additives on pyrolysis of pine wood sawdust by microwave heating , 2008 .

[20]  D. Fabbri,et al.  Effect of zeolites and nanopowder metal oxides on the distribution of chiral anhydrosugars evolved from pyrolysis of cellulose: An analytical study , 2007 .

[21]  D. Fabbri,et al.  Analytical study on the pyrolytic behaviour of cellulose in the presence of MCM-41 mesoporous materials , 2009 .

[22]  D. Meier,et al.  Pre-treatment of biomass with phosphoric acid prior to fast pyrolysis: A promising method for obtaining 1,6-anhydrosaccharides in high yields , 2003 .

[23]  M. Antal,et al.  Simultaneous thermogravimetric-mass spectrometric studies of the thermal decomposition of biopolymers. 1. Avicel cellulose in the presence and absence of catalysts , 1988 .

[24]  A. Khelfa,et al.  Influence of some minerals on the cellulose thermal degradation mechanisms , 2008 .

[25]  H. J. Heeres,et al.  Identification of components in fast pyrolysis oil and upgraded products by comprehensive two-dimensional gas chromatography and flame ionisation detection. , 2007, Journal of chromatography. A.

[26]  Qiang Lu,et al.  Catalytic upgrading of biomass fast pyrolysis vapors with titania and zirconia/titania based catalysts , 2010 .

[27]  Donald S. Scott,et al.  On the mechanism of the rapid pyrolysis of cellulose , 1986 .

[28]  Q. Guo,et al.  Catalytic pyrolysis of cellulose with sulfated metal oxides: a promising method for obtaining high yield of light furan compounds. , 2009, Bioresource technology.

[29]  S. Gu,et al.  The mechanism for thermal decomposition of cellulose and its main products. , 2009, Bioresource technology.

[30]  J. Satrio,et al.  Influence of inorganic salts on the primary pyrolysis products of cellulose. , 2010, Bioresource technology.

[31]  Xifeng Zhu,et al.  Catalytic Upgrading of Biomass Fast Pyrolysis Vapors with Pd/SBA-15 Catalysts , 2010 .

[32]  A. Bridgwater,et al.  Overview of Applications of Biomass Fast Pyrolysis Oil , 2004 .

[33]  D. Radlein,et al.  Fast pyrolysis of natural polysaccharides as a potential industrial process , 1991 .

[34]  C. Blasi,et al.  GC/MS characterization of liquids generated from low-temperature pyrolysis of wood , 2003 .

[35]  C. Blasi,et al.  Effects of Diammonium Phosphate on the Yields and Composition of Products from Wood Pyrolysis , 2007 .

[36]  Z. Dong,et al.  Analytical pyrolysis–gas chromatography/mass spectrometry (Py–GC/MS) of sawdust with Al/SBA-15 catalysts , 2009 .

[37]  Anthony V. Bridgwater,et al.  Fast pyrolysis of cassava rhizome in the presence of catalysts , 2008 .