Low Field Optimization of a Non-Contacting High-Sensitivity GMR-Based DC/AC Current Sensor

Many applications require galvanic isolation between the circuit where the current is flowing and the measurement device. While for AC, the current transformer is the method of choice, in DC and, especially for low currents, other sensing methods must be used. This paper aims to provide a practical method of improving the sensitivity and linearity of a giant magnetoresistance (GMR)-based current sensor by adapting a set of design rules and methods easy to be implemented. Our approach utilizes a multi-trace current trace and a double differential GMR based detection system. This essentially constitutes a planar coil which would effectively increase the usable magnetic field detected by the GMR sensor. An analytical model is developed for calculating the magnetic field generated by the current in the GMR sensing area which showed a significant increase in sensitivity up to 13 times compared with a single biased sensor. The experimental setup can measure both DC and AC currents between 2–300 mA, with a sensitivity between 15.62 to 23.19 mV/mA, for biasing fields between 4 to 8 Oe with a detection limit of 100 μA in DC and 100 to 300 μA in AC from 10 Hz to 50 kHz. Because of the double differential setup, the detection system has a high immunity to external magnetic fields and a temperature drift of the offset of about −2.59 × 10−4 A/°C. Finally, this setup was adapted for detection of magnetic nanoparticles (MNPs) which can be used to label biomolecules in lab-on-a-chip applications and preliminary results are reported.

[1]  Susana Cardoso,et al.  Electronic Energy Meter Based on a Tunnel Magnetoresistive Effect (TMR) Current Sensor , 2017, Materials.

[2]  Roland Weiss,et al.  Advanced giant magnetoresistance technology for measurement applications , 2013 .

[3]  Pavel Ripka,et al.  AMR current measurement device , 2008 .

[4]  Jorg Roth-Stielow,et al.  New evaluation of low frequency capture for a wide bandwidth clamping current probe for ±800 A using GMR sensors , 2011, Proceedings of the 2011 14th European Conference on Power Electronics and Applications.

[5]  Jun Hu,et al.  A Current Sensor Based on the Giant Magnetoresistance Effect: Design and Potential Smart Grid Applications , 2012, Sensors.

[6]  M. Avram,et al.  Using permalloy based planar hall effect sensors to capture and detect superparamagnetic beads for lab on a chip applications , 2015 .

[7]  J. Xu,et al.  Detection of the Concentration of MnFe2O4 Magnetic Microparticles Using Giant Magnetoresistance Sensors , 2016, IEEE Transactions on Magnetics.

[8]  T. Rijks,et al.  Semiclassical calculations of the anisotropic magnetoresistance of NiFe-based thin films, wires, and multilayers. , 1995, Physical review. B, Condensed matter.

[9]  Wenrong Yang,et al.  Optimization Design of a Giant Magneto Resistive Effect Based Current Sensor With a Magnetic Shielding , 2014, IEEE Transactions on Applied Superconductivity.

[10]  Micromagnetic simulations on detection of magnetic labelled biomolecules using MR sensors , 2009 .

[11]  Marius Volmer,et al.  High Sensitivity Differential Giant Magnetoresistance (GMR) Based Sensor for Non-Contacting DC/AC Current Measurement , 2020, Sensors.

[12]  Jongwon Park,et al.  Superparamagnetic nanoparticle quantification using a giant magnetoresistive sensor and permanent magnets , 2015 .

[13]  Wing Hong Lau,et al.  Extending the GMR Current Measurement Range with a Counteracting Magnetic Field , 2013, Sensors.

[14]  Pavel Ripka,et al.  AC/DC Current Transformer With Single Winding , 2014, IEEE Transactions on Magnetics.

[15]  Martijn F. Snoeij,et al.  Integrated Fluxgate Magnetometer for Use in Isolated Current Sensing , 2016, IEEE Journal of Solid-State Circuits.

[16]  Klaus Hofmann,et al.  Noise study of open-loop direct current-current transformer using magneto-resistance sensors , 2016, 2016 IEEE Sensors Applications Symposium (SAS).

[17]  J. Lenz.  A review of magnetic sensors , 1990, Proc. IEEE.

[18]  Zhichao Li,et al.  A Closed-Loop Operation to Improve GMR Sensor Accuracy , 2016, IEEE Sensors Journal.

[19]  Pavel Ripka,et al.  Rectangular Array Electric Current Transducer with Integrated Fluxgate Sensors , 2019, Sensors.

[20]  Signal dependence on magnetic nanoparticles position over a planar Hall effect biosensor , 2013 .

[21]  Sungho Lee,et al.  High Accuracy Open-Type Current Sensor with a Differential Planar Hall Resistive Sensor , 2018, Sensors.

[22]  Ivan Yatchev,et al.  Modelling of a Hall Effect-Based Current Sensor with an Open Core Magnetic Concentrator , 2018, Sensors.

[23]  Daniel Klaas,et al.  Recent Developments of Magnetoresistive Sensors for Industrial Applications , 2015, Sensors.

[24]  P. Ripka.  Electric current sensors: a review , 2010 .

[25]  Sein Oh,et al.  Low Power CMOS-Based Hall Sensor with Simple Structure Using Double-Sampling Delta-Sigma ADC , 2020, Sensors.

[26]  Robert Weigel,et al.  Linearizing the Output Characteristic of GMR Current Sensors Through Hysteresis Modeling , 2010, IEEE Transactions on Industrial Electronics.