Modeling and Characterization of Current Gain Versus Temperature in 4H-SiC Power BJTs

Accurate physical modeling has been developed to describe the current gain of silicon carbide (SiC) power bipolar junction transistors (BJTs), and the results have been compared with measurements. Interface traps between SiC and SiO2 have been used to model the surface recombination by changing the trap profile, capture cross section, and concentration. The best agreement with measurement is obtained using one single energy level at 1 eV above the valence band, a capture cross section of 1 × 10-5 cm2, and a trap concentration of 2 × 1012 cm-2. Simulations have been performed at different temperatures to validate the model and characterize the temperature behavior of SiC BJTs. An analysis of the carrier concentration at different collector currents has been performed in order to describe the mechanisms of the current gain fall-off at a high collector current both at room temperature and high temperatures. At room temperature, high injection in the base (which has a doping concentration of 3 × 1017 cm-3) and forward biasing of the base-collector junction occur simultaneously, causing an abrupt drop of the current gain. At higher temperatures, high injection in the base is alleviated by the higher ionization degree of the aluminum dopants, and then forward biasing of the base-collector junction is the acting mechanism for the current gain fall-off. Forward biasing of the base-collector junction can also explain the reduction of the knee current with increasing temperature by means of the negative temperature dependence of the mobility.

[1]  H. Mitlehner,et al.  SiC devices: physics and numerical simulation , 1994 .

[2]  A. Lelis,et al.  The Effect of Nitridation on SiC MOS Oxides as Evaluated by Charge Pumping , 2008 .

[3]  M. Ostling,et al.  Geometrical effects in high current gain 1100-V 4H-SiC BJTs , 2005, IEEE Electron Device Letters.

[4]  Tsunenobu Kimoto,et al.  Interface Properties of Metal–Oxide–Semiconductor Structures on 4H-SiC{0001} and (1120) Formed by N2O Oxidation , 2005 .

[5]  R. Singh,et al.  1800 V NPN bipolar junction transistors in 4H-SiC , 2001, IEEE Electron Device Letters.

[6]  Christer Hallin,et al.  The minority carrier lifetime of n‐type 4H‐ and 6H‐SiC epitaxial layers , 1996 .

[7]  A. Agarwal,et al.  Base Current Gain of Power (1800 V, 10 A) 4H-SiC npn-BJTs , 2004 .

[8]  Akihiko Horiuchi,et al.  A New High Current Gain 4H-SiC Bipolar Junction Transistor with Suppressed Surface Recombination Structure: SSR-BJT , 2009 .

[9]  Anant K. Agarwal,et al.  Interface trap profile near the band edges at the 4H-SiC/SiO2 interface , 2000 .

[10]  A. Agarwal,et al.  Temperature dependence of the current gain in power 4H-SiC NPN BJTs , 2006, IEEE Transactions on Electron Devices.

[11]  U. Lindefelt.  Doping-induced band edge displacements and band gap narrowing in 3C-, 4H- 6H-SiC and Si , 1998 .

[12]  Maurice Weiner,et al.  On the temperature coefficient of 4H-SiC BJT current gain , 2003 .

[13]  O. W. Holland,et al.  Improved inversion channel mobility for 4H-SiC MOSFETs following high temperature anneals in nitric oxide , 2001, IEEE Electron Device Letters.

[14]  Leonard C. Feldman,et al.  Nitrogen and Hydrogen Induced Trap Passivation at the SiO2/4H-SiC Interface , 2006 .

[15]  Carl-Mikael Zetterling,et al.  Surface passivation oxide effects on the current gain of 4H-SiC bipolar junction transistors , 2008 .

[16]  R. Ghandi,et al.  Fabrication of 2700-V 12-$\hbox{m}\Omega \cdot \hbox{cm}^{2}$ Non Ion-Implanted 4H-SiC BJTs With Common-Emitter Current Gain of 50 , 2008, IEEE Electron Device Letters.

[17]  S. Bayne,et al.  1000-V, 30-A 4H-SiC BJTs with high current gain , 2005, IEEE Electron Device Letters.