论文信息 - Microstructure and mechanical properties of spray-deposited Al–Zn–Mg–Cu alloy

Microstructure and mechanical properties of spray-deposited Al–Zn–Mg–Cu alloy

Abstract In this study, Al–10.8Zn–2.8Mg–1.9Cu alloy was synthesized by the spray atomization and deposition technique. The microstructure and mechanical properties of the alloy were studied using optical microscopy, transmission electron microscopy, X-ray diffraction, and tensile tests. The secondary phases in the microstructure of the spray-deposited alloy were examined. The tensile test results indicate that the spray-deposited Al–10.8Zn–2.8Mg–1.9Cu alloy displays superior tensile strength due to the presence of precipitating strengthening phases.

[1] Fei Wang,et al. Microstructural characterization of in situ TiC/Al and TiC/Al-20Si-5Fe-3Cu-1Mg composites prepared by spray deposition , 2003 .

[2] X. Duan,et al. Liquid dynamic compaction of aluminum alloy 7150 , 1993 .

[3] M. Sanctis. Structure and properties of rapidly solidified ultrahigh strength AlZnMgCu alloys produced by spray deposition , 1991 .

[4] X. Z. Li,et al. HREM study and structure modeling of the η′ phase, the hardening precipitates in commercial Al–Zn–Mg alloys , 1999 .

[5] X. Z. Li,et al. GP-zones in Al–Zn–Mg alloys and their role in artificial aging , 2001 .

[6] Jie Zhou,et al. Structural development during the extrusion of rapidly solidified Al-20Si-5Fe-3Cu-1Mg alloy , 1991 .

[7] E. Lavernia,et al. Microstructure and mechanical behavior of spray deposited Zn modified 7XXX series Al alloys , 1995 .