Development of diagnostic systems for the fault tolerant operation of Micro-Grids.

The progressive penetration level of Distributed Generation (DG) is destined to cause deep changes in the existing distribution networks no longer considered as passive terminations of the whole electrical system. A possible solution is the realization of small networks, namely the Micro-Grids, reproducing in themselves the structure of the main production and distribution of the electrical energy system. In order to gain an adequate reliability level of the micro-grids the individuation and the management of the faults with the goal of maintaining the micro-grid operation (fault tolerant operation) is quite important. In the present paper after the introduction of the aims of several diagnostic systems, the main available diagnostic techniques are examined with particular references to those applied to the fault diagnosis of the electrical machines and finally the Authors also present an approach for the fault tolerant exercise of the micro-grid.

[1]  Hamid A. Toliyat,et al.  Transient analysis of cage induction machines under stator, rotor bar and end ring faults , 1995 .

[2]  J. C. Salmon Current overload protection features of hybrid inverter drives , 1992, Proceedings of the 1992 International Conference on Industrial Electronics, Control, Instrumentation, and Automation.

[3]  Wei Zhou,et al.  Bearing Condition Monitoring Methods for Electric Machines: A General Review , 2007, 2007 IEEE International Symposium on Diagnostics for Electric Machines, Power Electronics and Drives.

[4]  E. Tironi,et al.  Integrazione e gestione della generazione distribuita collegata alla rete di distribuzione MT/BT , 2003 .

[5]  J. Kapler,et al.  Stator winding monitoring , 1998 .

[6]  T.A. Lipo,et al.  Fault tolerant three-phase AC motor drive topologies: a comparison of features, cost, and limitations , 2003, IEEE Transactions on Power Electronics.

[7]  Jim Penman,et al.  Induction machine condition monitoring with higher order spectra , 2000, IEEE Trans. Ind. Electron..

[8]  H. Behbahanifard,et al.  Non-invasive on-line detection of winding faults in induction motors—A review , 2008, 2008 International Conference on Condition Monitoring and Diagnosis.

[9]  Shahram Karimi,et al.  FPGA-Based Real-Time Power Converter Failure Diagnosis for Wind Energy Conversion Systems , 2008, IEEE Transactions on Industrial Electronics.

[10]  Peter Tavner,et al.  Monitoring generators and large motors , 1986 .

[11]  J. Penman,et al.  Detection and location of interturn short circuits in the stator windings of operating motors , 1994 .

[12]  R. Miceli,et al.  Monitoring and diagnosis of failures in squirrel-cage induction motors due to cracked or broken bars , 2011, 8th IEEE Symposium on Diagnostics for Electrical Machines, Power Electronics & Drives.