Experimental investigation of high strain-rate behaviour of fabric composites

Abstract Experimental observations confirm strain-rate-dependant behaviour of woven fabric composites; however, there is no consistent data available on characterization and modelling of this behaviour. This paper presents experimental results on rate-dependant damage behaviour of woven composites and using the same test setup, compares fabric composites with three different fibre architectures (i.e. plain weave, 2 × 2 twill weaves and 8-harness satin weaves) and two different materials (i.e. carbon/epoxy and carbon/BMI). High strain-rate dynamic tests are performed using a tensile version of the Hopkinson bar setup. Total of 103 uniaxial tension and bias extension specimens are tested to study and compare strain-rate-dependant behaviour of these materials. Test setup and results are presented and discussed in this paper. In general, higher maximum stress and initial undamaged tension and shear modulus are observed in dynamic tests compared to quasi-static ones. It is also observed that the shear behaviour of woven composites is more rate-dependant than their tensile behaviour.

[1]  Nicholas A. Warrior,et al.  The static and high strain rate behaviour of a commingled E-glass/polypropylene woven fabric composite , 2010 .

[2]  Amos Gilat,et al.  Experimental study of strain-rate-dependent behavior of carbon/epoxy composite , 2002 .

[3]  D. Adams,et al.  Rate Sensitive Tensile Impact Properties of Fully and Partially Loaded Unidirectional Composites , 1982 .

[4]  J. Harding,et al.  EFFECT OF STRAIN RATE ON THE TENSILE FAILURE OF WOVEN REINFORCED POLYESTER RESIN COMPOSITES , 1985 .

[5]  L. Gornet,et al.  A Rate Dependent Constitutive Model for Carbon-Fiber Reinforced Plastic Woven Fabrics , 2007 .

[6]  N. K. Naik,et al.  High strain rate tensile behavior of woven fabric E-glass/epoxy composite , 2010 .

[7]  I. Daniel,et al.  In-plane mechanical, thermal and viscoelastic properties of a satin fabric carbon/epoxy composite , 2004 .

[8]  M. Benzeggagh,et al.  Comparative study of strain rate effects on mechanical properties of glass fibre-reinforced thermoset matrix composite , 1996 .

[9]  V.P.W. Shim,et al.  An analysis of stress uniformity in split Hopkinson bar test specimens , 2005 .

[10]  C. Sciammarella,et al.  Response of glass-fiber-reinforced epoxy specimens to high rates of tensile loading , 1973 .

[11]  K. Reifsnider,et al.  Characterization of Nonlinear Behavior in Woven Composite Laminates , 2002, Applied Composite Materials.

[12]  T. Takeda,et al.  Mechanical Characterization of CFRP Woven Laminates between Room Temperature and 4K , 2003 .

[13]  C. Ruiz,et al.  Measurement of the properties of woven CFRP T300/914 at different strain rates , 2000 .

[14]  Grant P. Steven,et al.  Behavior of 3D orthogonal woven CFRP composites. Part I. Experimental investigation , 2000 .

[15]  K. Gliesche,et al.  Investigations of in-plane shear properties of ±45°-carbon/epoxy composites using tensile testing and optical deformation analysis , 2005 .

[16]  S. Werner,et al.  The Dynamic Response of Graphite Fiber-Epoxy Laminates at High Shear Strain Rates , 1986 .

[17]  J. Harding,et al.  A tensile testing technique for fibre-reinforced composites at impact rates of strain , 1983 .

[18]  Alastair Johnson,et al.  Computational methods for predicting impact damage in composite structures , 2001 .

[19]  U. Khashaba.  In-plane shear properties of cross-ply composite laminates with different off-axis angles , 2004 .

[20]  Amos Gilat,et al.  A direct-tension split Hopkinson bar for high strain-rate testing , 1991 .

[21]  B. Harris,et al.  Strength and fracture toughness of carbon fibre polyester composites , 1971 .

[22]  V. Sánchez-Gálvez,et al.  High strain rate properties of aramid and polyethylene woven fabric composites , 1996 .

[23]  H. Kolsky.  An Investigation of the Mechanical Properties of Materials at very High Rates of Loading , 1949 .

[24]  Hoon Huh,et al.  A tension split Hopkinson bar for investigating the dynamic behavior of sheet metals , 2002 .

[25]  N. Hancox.  Izod impact testing of carbon-fibre-reinforced plastics , 1971 .

[26]  C. Chiem,et al.  The Relationship Between Tensile Strength and Shear Strength in Composite Materials Subjected to High Strain Rates , 1988 .

[27]  John W. Gillespie,et al.  Hopkinson bar experimental technique: A critical review , 2004 .

[28]  D. Adams,et al.  A tensile impact test apparatus for composite materials , 1989 .

[29]  Gilbert Lebrun,et al.  Evaluation of bias-extension and picture-frame test methods for the measurement of intraply shear properties of PP/glass commingled fabrics , 2003 .

[30]  S. L. Ogin,et al.  Damage accumulation in woven-fabric CFRP laminates under tensile loading: Part 1. Observations of damage accumulation , 1999 .

[31]  M. M. Al-Mousawi,et al.  The use of the split Hopkinson pressure bar techniques in high strain rate materials testing , 1997 .

[32]  J. Lifshitz.  Impact Strength of Angle Ply Fiber Reinforced Materials , 1976 .

[33]  T. Schmidt,et al.  Full field strain measurement during a tensile split Hopkinson bar experiment , 2006 .