A Distributed Architecture Based on Microbank Modules With Self-Reconfiguration Control to Improve the Energy Efficiency in the Battery Energy Storage System

This paper proposes a new distributed battery energy architecture based on the microbank module (MBM) for dc microgrids. The benefits of the proposed architecture include: 1) no voltage sharing problem and no overcharge/overdischarge problem; 2) high compatibility and reliability; 3) high energy utilization efficiency; 4) reduced volume and weight of the battery management system (BMS). The proposed MBM consists of a microbidirectional dc/dc converter, a micro-BMS and a cell bank. Moreover, taking advantage of the battery recovery effect, a self-reconfiguration discharge strategy is also proposed to further enhance the battery performance and discharge efficiency of the new battery energy storage system (BESS). To optimize the proposed control, an efficiency analytical model considering the battery recovery effect is proposed using the curve fitting method. Owing to the bidirectional capability, soft switching capability and high efficiency, the dual active bridge (DAB) converters are chosen as the microbidirectional dc/dc converters. A hybrid modulation strategy with variable switching frequency combining the conventional phase-shift modulation and triangular current modulation is proposed for the DAB converter to reduce the dominant loss and improve the efficiency in wide load range based on the minimum loss model. A 1.5-kW experimental testing platform consisting of four MBMs and four 12 V/100 Ah lithium battery modules was built to verify the proposed architecture with the control and the proposed model. The experimental results show that the discharge time of the proposed distributed BESS is increased significantly under wide operation condition with the self-reconfiguration control. The discharge efficiency of the BESS is improved by 7.1% with the idling time of 5 min under the power level of 1.5 kW.

[1]  James W. Evans,et al.  Electrochemical‐Thermal Model of Lithium Polymer Batteries , 2000 .

[2]  Qingguang Yu,et al.  Extended-Phase-Shift Control of Isolated Bidirectional DC–DC Converter for Power Distribution in Microgrid , 2012, IEEE Transactions on Power Electronics.

[3]  I. Batarseh,et al.  A review of distributed power systems. Part II. High frequency AC distributed power systems , 2006, IEEE Aerospace and Electronic Systems Magazine.

[4]  Shaojun Xie,et al.  Voltage-Fed Dual Active Bridge Bidirectional DC/DC Converter With an Immittance Network , 2014, IEEE Transactions on Power Electronics.

[5]  Yehea I. Ismail,et al.  New hybrid battery model that takes into account both electric circuit characteristics and non-linear battery properties , 2013, 2013 IEEE 20th International Conference on Electronics, Circuits, and Systems (ICECS).

[6]  Wei Qiao,et al.  A series-connected self-reconfigurable multicell battery capable of safe and effective charging/discharging and balancing operations , 2012, 2012 Twenty-Seventh Annual IEEE Applied Power Electronics Conference and Exposition (APEC).

[7]  Xiaodong Li,et al.  An Optimized Phase-Shift Modulation For Fast Transient Response in a Dual-Active-Bridge Converter , 2014, IEEE Transactions on Power Electronics.

[8]  A K Jain,et al.  Pwm control of dual active bridge: Comprehensive analysis and experimental verification , 2011, IEEE Transactions on Power Electronics.

[9]  J. Kolar,et al.  Closed Form Solution for Minimum Conduction Loss Modulation of DAB Converters , 2012, IEEE Transactions on Power Electronics.

[10]  Anshul Kumar,et al.  Battery model for embedded systems , 2005, 18th International Conference on VLSI Design held jointly with 4th International Conference on Embedded Systems Design.

[11]  R. D. De Doncker,et al.  Impedance-based simulation models of supercapacitors and Li-ion batteries for power electronic applications , 2003, IEEE Transactions on Industry Applications.

[12]  R. Gordon,et al.  Linearized Large Signal Modeling , Analysis , and Control Design of Phase-Controlled Series-Parallel Resonant Converters Using State Feedback , 2016 .

[13]  R.H. Lasseter,et al.  Microgrid: a conceptual solution , 2004, 2004 IEEE 35th Annual Power Electronics Specialists Conference (IEEE Cat. No.04CH37551).

[14]  T. Kim,et al.  A Hybrid Battery Model Capable of Capturing Dynamic Circuit Characteristics and Nonlinear Capacity Effects , 2011, IEEE Transactions on Energy Conversion.

[15]  Roger A. Dougal,et al.  Dynamic lithium-ion battery model for system simulation , 2002 .

[16]  Wenhua Liu,et al.  Overview of Dual-Active-Bridge Isolated Bidirectional DC–DC Converter for High-Frequency-Link Power-Conversion System , 2014, IEEE Transactions on Power Electronics.

[17]  Dushan Boroyevich,et al.  Intergrid: A Future Electronic Energy Network? , 2013, IEEE Journal of Emerging and Selected Topics in Power Electronics.

[18]  Cassiano Rech,et al.  Integrated Full-Bridge-Forward DC–DC Converter for a Residential Microgrid Application , 2013, IEEE Transactions on Power Electronics.

[19]  Yang Yang,et al.  Harnessing battery recovery effect in wireless sensor networks: Experiments and analysis , 2010, IEEE Journal on Selected Areas in Communications.

[20]  Wenhua Liu,et al.  Efficiency Characterization and Optimization of Isolated Bidirectional DC–DC Converter Based on Dual-Phase-Shift Control for DC Distribution Application , 2013, IEEE Transactions on Power Electronics.

[21]  Kai Strunz,et al.  DC Microgrid for Wind and Solar Power Integration , 2014, IEEE Journal of Emerging and Selected Topics in Power Electronics.

[22]  V. Battaglia,et al.  Electrochemical modeling of lithium polymer batteries , 2002 .

[23]  Dushan Boroyevich,et al.  Lithium-based energy storage management for DC distributed renewable energy system , 2011, 2011 IEEE Energy Conversion Congress and Exposition.

[24]  Song Ci,et al.  Dynamic reconfigurable multi-cell battery: A novel approach to improve battery performance , 2012, 2012 Twenty-Seventh Annual IEEE Applied Power Electronics Conference and Exposition (APEC).

[25]  D. Wheeler,et al.  Modeling of lithium-ion batteries , 2003 .

[26]  Z. Ye Dual Half-Bridge DC–DC Converter With Wide-Range ZVS and Zero Circulating Current , 2013, IEEE Transactions on Power Electronics.

[27]  Yang Yang,et al.  Battery recovery aware sensor networks , 2009, 2009 7th International Symposium on Modeling and Optimization in Mobile, Ad Hoc, and Wireless Networks.

[28]  Min Chen,et al.  Accurate electrical battery model capable of predicting runtime and I-V performance , 2006, IEEE Transactions on Energy Conversion.

[29]  T. Abe,et al.  Design and Performance of a Bidirectional Isolated DC–DC Converter for a Battery Energy Storage System , 2012, IEEE Transactions on Power Electronics.