Wall coating behavior of catalyst slurries in non-porous ceramic microstructures

Abstract We report the use of the gas-displacement technique to generate wall coatings of catalyst slurries in fused silica capillaries, as well as ceramic microreactors. The non-porous and glassy surfaces make it difficult to prepare adherent coatings within ceramic structures. In the fused silica capillaries, we were able to show adherent catalyst coats up to 20 μ m thick and found that the maximum fraction coated decreased as the capillary diameter decreased. We developed a model for the various diameters showing the relationship of the fraction coated versus the capillary number, Ca. It was determined that the coating behavior was controlled by the coupled effects of the fluid rheology and the dramatic increase in the Reynold's number as the diameters decreased. For the ceramic microreactor, we determined that the coatings were adherent and tests showed the wall-coated catalyst in these structures to be catalytically active for the steam reforming of methanol.

[1]  K. Jensen,et al.  Design and fabrication of microfluidic devices for multiphase mixing and reaction , 2002 .

[2]  A. Datye,et al.  Comparison of wall-coated and packed-bed reactors for steam reforming of methanol , 2005 .

[3]  Gas-assisted non-newtonian fluid displacement in circular tubes and noncircular channels , 2001 .

[4]  F. Kamişli.  Free coating of a non-Newtonian liquid onto walls of a vertical and inclined tube , 2003 .

[5]  M. E. Ryan,et al.  Gas‐assisted fluid displacement in a circular tube and a rectangular channel , 2002 .

[6]  Klavs F. Jensen,et al.  Microfabricated multiphase packed-bed reactors : Characterization of mass transfer and reactions , 2001 .

[7]  K. Kusakabe,et al.  Development of a microchannel catalytic reactor system , 2001 .

[8]  A. Datye,et al.  Nonisothermality in packed bed reactors for steam reforming of methanol , 2005 .

[9]  Zhanfeng Cui,et al.  Hydrodynamics of slug flow inside capillaries , 2004 .

[10]  K. Sotowa,et al.  Fabrication of Parallel Microchannel Reactors for Use in Catalyst Testing , 2002 .

[11]  Abhaya K. Datye,et al.  Wall coating of a CuO/ZnO/Al2O3 methanol steam reforming catalyst for micro-channel reformers , 2004 .

[12]  D. Browning,et al.  An investigation of hydrogen storage methods for fuel cell operation with man-portable equipment , 1997 .

[13]  K. Warrier,et al.  Effect of nanoparticulate boehmite sol as a dispersant for slurry compaction of alumina ceramics , 2000 .

[14]  G. Taylor.  Deposition of a viscous fluid on the wall of a tube , 1961, Journal of Fluid Mechanics.

[15]  A. Wolf,et al.  Microreactors – A New Efficient Tool for Reactor Development , 2001 .

[16]  Yong Wang,et al.  Development of a soldier-portable fuel cell power system. Part I: A bread-board methanol fuel processor , 2002 .

[17]  Gas displacing liquids from non-circular tubes: high capillary number flow of a shear-thinning liquid , 2005 .

[18]  F. Kamişli.  Flow of a long bubble in a square capillary , 2003 .

[19]  J. Sienz,et al.  Gas displacing liquids from tubes: high capillary number flow of a power law liquid including inertia effects , 2004 .